2005 Ford F550 Xl Super Duty Flatbed Work Truck 4x4 on 2040-cars

Auto blog

These horribly misguided front-drive design studies nearly became the Mustang

As we eagerly await the unveiling of the all-new sixth-generation Mustang, Ford has been giving us some great information over the past few months showing what has gone into shaping its venerable pony car. As many changes as the Mustang has gone through in its 50 years, though, it appears the fourth-gen model played a decisive and pivotal role in the car's future.
As is part of Mustang lore, the front-wheel drive Ford Probe was originally developed as a next-generation Mustang in the Eighties before cooler heads prevailed. The Blue Oval has just released a handful of images showing how bad things could have been - including a full-scale clay model of a front-wheel-drive Mustang (shown above). Fortunately, the FWD Mustang plan was scrapped and Ford went to work designing a rear-wheel-drive replacement for the Fox Body Mustang, with three design studies making it far enough to become full-scale models. These include the soft "Bruce Jenner" Mustang, the over-the-top "Rambo" Mustang and the middle-ground "Arnold Schwarzenegger" Mustang, which finally became the basis for the 1994 'Stang.
By early 1991, the design language of the fourth-generation Mustang had been worked out, and the rest, they say, is history. Scroll down for the fascinating press release telling the story of the fourth-gen Mustang, and be sure to check out the gallery of horribly misguided sketches and various design studies that were all on the table in the late 1980s.

Ford recalling 2015 Mustang for fuel line leak, 20K Transit Connects for plastic panel

Ford is recalling 738 examples of the 2015 2015 Mustang with the 2.3-liter EcoBoost engine – 712 in the US, 16 in Canada. A fuel pressure sensor might have been installed incorrectly on the affected cars, and that could result in a fuel leak. At the time of writing the company hasn't heard any reports of any incidents related to the issue, and parties with affected vehicles can take them to the dealer to have the fuel tube assembly replaced free of charge. The 2014 Transit Connect Cargo Van is also the subject of a safety recall, due to a possible problem with adhesive used on the exterior plastic panel on the sliding doors. There are 19,825 units covered by that recall, which dealers will also repair free of charge. You can find more information on both bulletins in the press releases below. Ford Issues Safety Recall for Certain 2015 Mustang Vehicles in North America for Fuel Pressure Sensor Issue Dec 4, 2014 | DEARBORN, Mich. - Ford is issuing a safety recall for approximately 730 2015 Ford Mustang vehicles in North America (actual 728) for a potential fuel line leak. A fuel pressure sensor, which is part of the fuel supply tube assembly, may have been installed incorrectly, potentially resulting in a pressurized fuel leak. A fuel leak in the presence of an ignition source may result in a fire. Ford is not aware of any fires, accidents or injuries related to this condition. Affected vehicles include certain 2015 Ford Mustangs equipped with 2.3-liter engines built at Flat Rock Assembly Plant, Sept. 25, 2014 to Oct. 9, 2014. Ford is aware of 712 vehicles in the United States and federalized territories and 16 in Canada. These totals are as of Dec. 3, 2014. Dealers will replace the fuel supply tube assembly at no cost to the customer. *** Ford Issues Safety Recall for Certain 2014 Transit Connect Cargo Van Vehicles in North America for Issue with the Plastic Panel on the Sliding Doors Dec 4, 2014 | DEARBORN, Mich. - Ford is issuing a safety recall for approximately 20,000 2014 Transit Connect cargo van vehicles in North America (actual 19,825) for an issue with adhesion of an exterior plastic panel to the sliding doors. This issue may result in noise, a water leak, a loose panel, or separation of the plastic panel from the vehicle while driving, potentially increasing the risk of an accident or injury. Ford is not aware of any accidents or injuries related to this condition.

Ring Brothers shows 1965-66 Mustang fastback carbon fiber body

We covered one of Ring Brothers' more extreme SEMA builds yesterday, the De Tomaso Pantera-based ADRNLN, but if that well-executed but over-the-top Italian-American exotic is too much for you, then perhaps this Ring Brothers 1965 Ford Mustang fastback with a carbon-fiber body suits your tastes better.
What the performance-parts manufacturer is showcasing with the Mustang is the carbon-fiber body itself, which is fashioned around the 1965-66 fastback. It can be bought from the company and bonded to the skin and unibody as a do-it-yourself project, or you can take your Mustang to Ring Brothers and have the body installed there. The fenders, doors and quarter panels are two-inches wider than stock, and Ring Brothers offers a custom widebody chassis to those who want the complete package.
The show car looks sharp in person lowered on HRE wheels, and we appreciate the bare front end so we can see the supercharged V8 and front coilover suspension, though the details on those performance upgrades are slim. Also note the custom independent rear suspension setup at the rear.