1951 F6 Ford Truck Trailer Toter on 2040-cars

Auto blog

Ford Mustang Mach-E fails Sweden's moose test

The infamous moose test has claimed another casualty. This time it's the Ford Mustang Mach-E AWD Long Range, which was tested in an electric four-way alongside the Tesla Model Y, Hyundai Ioniq 5 and Skoda Enyaq iV (an electric utility vehicle closely related to the Volkswagen ID.4 that is sold in the United States). According to the Swedish testers at Teknikens Varld, Ford's electric car not only failed to hit the speed necessary for a passing grade, it didn't perform well at slower speeds, either. To pass the outlet's moose test, a car has to complete a rapid left-right-straight S-shaped pattern marked by cones at a speed of at least 72 km/h (44.7 miles per hour). The test is designed to mimic the type of avoidance maneuver a driver would have to take in order to avoid hitting something that wandered into the road, which in Sweden may be a moose but could just as easily be a deer or some other member of the animal kingdom elsewhere in the world, or possibly a child or car backing into the motorway. Not only is the maneuver very aggressive, it's also performed with weights belted into each seat and more weight added to the cargo area to hit the vehicle's maximum allowable carrying capacity. The Mustang Mach-E only managed to complete the moose test at 68 km/h (42.3 mph), well below the passing-grade threshold. Even at much lower speeds, Teknikens Varld says the Mach-E (which boasts the highest carrying capacity and was therefore loaded with more weight than the rest of the vehicles tested in this quartet) is "too soft in the chassis" and suffers from "too slow steering." Proving that it is indeed possible to pass the test, the Hyundai and Skoda completed the maneuver at the 44.7-mph figure required for a passing grade and the Tesla did it at 46.6 mph, albeit with less weight in the cargo area. It's not clear whether other versions of the Mustang Mach-E would pass the test. It's also unknown if Ford will make any changes to its chassis tuning or electronic stability control software, as some other automakers have done after a poor performance from Teknikens Varld, to improve its performance in the moose test. Related video:

NHTSA and Ford investigating steering issues in Crown Vic, Grand Marquis and Marauder

There may be more steering woes for the Ford Crown Victoria. The National Highway Traffic Safety Administration has opened a preliminary evaluation into the Crown Vic and Mercury Grand Marquis from the 2004 to 2007 model years and the Mercury Marauder for the 2004 and 2005 model years because the steering shaft can jam. The issue could potentially affect an estimated 500,000 vehicles.
According to the regulator, there is a possibility that the driver's side heat shield for the exhaust manifold can rust, dislodge, and then wedge into the steering shaft. If this occurs, it leads to a situation where the driver can no longer control the car.
NHTSA has received five complaints of this happening, including one alleged case with an injury. In that situation, the car was driving onto the highway, lost control and rolled over. One occupant was hurt in the accident.

NHTSA closes Ford F-150 EcoBoost acceleration probe

Typically when we report on the findings of an investigation from the National Highway Traffic Safety Administration, it's because the government body has discovered a safety issue and prescribed a recall. In this case, however, NHTSA has closed an investigation into a reported performance deficit without ever getting to the recall stage.
The issue revolves around the Ford F-150 - specifically those equipped with the 3.5-liter EcoBoost engine - of which some 360,000 were built in the 2011, 2012 and 2013 model years. After receiving an initial 95 complaints, NHTSA opened an investigation last May - almost a year ago - into the reported issue of reduced engine power under hard acceleration. The agency has since received a total of 525 such complaints, and Ford itself reported receiving over 4,000.
Together, NHTSA and Ford determined that the problem resulted from cylinders misfiring, an issue itself stemming from water getting into the charge air cooler (CAC) mated to the turbochargers. In particularly humid or rainy conditions, water was found to get into the CAC, causing some of the cylinders to misfire, which in turn triggered the ECU to disable those cylinders in order to protect the catalytic converter from damage.