1965 Ford Galaxie 500 Convertible 390v8 Cruise O Matic Trans Power Top New Paint on 2040-cars

Auto blog

Ford cleans up painting process with cameras

Knowing how the bacon gets made rarely entices us and, in the same vein, the same usually goes for knowing about how new cars get painted. But in both instances, however, quality - or a lack thereof - is instantly obvious. In terms of the latter, Ford is showing off its new paint quality process with 3D Dirt Detection Technology to find imperfections in vehicle paint more easily and more quickly.
This process - being performed on the F-150 SVT Raptor above - uses 16 computer-controlled cameras to create a three-dimensional model (inset) of the vehicle to detect flaws in the paint including dirt particles, which can then be buffed out manually. Ford says this new technology cuts down on time spent looking for paint flaws and gives workers more time to correct those that are discovered.
Currently, Ford only uses its 3D Dirt Detection Technology system at three factories (the Dearborn, MI facility, along with those in Louisville, Kentucky and Valencia, Spain), but it will soon spread to five more plants in North America. Ford has released a video and press release for this innovative and unexpectedly interesting process, both of which are posted below.

Ford Fusion demand outstripping supply

The attractive new 2013 Ford Fusion has done wonders for the brand in the highly competitive midsize sedan segment - the vehicle is up nearly 22 percent compared to last year. But that sales momentum may soon hold steady due to low inventory levels of the new Fusion across the United States.
According to a report in The Detroit News, citing automotive data and Ward's Auto, Ford currently has a 39-day supply of the Fusion. That might sound fine, but a normally healthy average is about a 60-day supply. If Ford were to stop production on the Fusion today, there would only be enough vehicles available to get through another five weeks of sales, according to the News.
Currently, Ford produces the Fusion at its three-shift assembly plant in Hermosillo, Mexico, and will add production at its facility in Flat Rock, MI later this year. A Ford spokesperson told The Detroit News that when Flat Rock production comes online, the automaker will need to rush new stock out to the regions with the most demand for the Fusion. Ford has doubled its coastal retail market share, with huge amounts of growth in areas like Los Angeles, San Francisco and Miami, the News reports.

Ford F-150 EcoBoost in NHTSA probe for acceleration issue

According to Automotive News, the National Highway Traffic Safety Administration is launching a probe into 400,000 Ford F-150 models over possible acceleration problems. According to the article, NHTSA has received 95 reports "alleging incidents of reduced engine power during hard accelerations" on 2011 to 2013 F-150 models equipped with the company's 3.5-liter EcoBoost V6 engine.
Automotive News reports that Ford has issued three technical service bulletins "related to intermittent stumble/misfire on acceleration from highway cruise in humid or damp conditions," according to the government agency's documents. About one third of the 95 reports NHTSA has received cited humid or rainy conditions when these problems allegedly occurred.
These technical service bulletins have allowed dealers to address a "condition related to moisture accumulation in the charge air cooler during extended highway cruising at constant throttle in humid or damp conditions," AN reports, citing NHTSA documents. Furthermore, the TSB outlines details for "reprogramming the powertrain control module with the latest calibration and installing a new CAC and air deflector plate."