2006 Ford Gt 2-door 5.4l on 2040-cars

Auto blog

VW going turbo-only in 3 to 4 years

This really was a matter of when, rather than if. Volkswagen will apparently be the first manufacturer to phase out naturally aspirated engines in favor of turbocharging its full slate. VW is kind of responsible for ushering in this push towards small-displacement, turbocharged engines that's taken the industry by storm. When it dropped its direct-injection, 2.0-liter turbo in the 2005 GTI it demonstrated that strapping an iron long to an engine can enhance the powertrain as a whole. VW made fuel economy gains, while also giving a linear, non-laggy turbo experience that it has replicated, model-after-model, to this day.
Speaking with The Detroit News, Volkswagen's executive Vice President of Group Quality, Marc Trahan, told the paper that, "We only have one normally aspirated gas engine, and when we go to the next generation vehicle that it's in, it will be replaced. So three, four years maximum."
Really, it's hard to get teary-eyed about either of these engines going away. VW has access to smaller powerplants that could easily match the performance of the 2.5 five-cylinder and the 3.6 V6, while gobbling up less fuel and providing a better driving experience. What we are sad about is that a similar statement about the extinction of NA engines came from the Vice President of Powertrain Engineering at Ford, Joe Bakaj. We'd certainly get teary-eyed over a world without Ford's excellent 5.0-liter V8.

Ford Q3 pretax profits drop to $1.18B

Following positive third quarter financial results recently from General Motors, rival Ford took a tumble in Q3. The automaker posted pre-tax profits of $1.18 billion, compared to about $2.59 billion in Q3 2013, a drop of around 54 percent. Net income also suffered with $835 million made in the quarter, versus $1.272 billion last year, a decline of about 34 percent. The Blue Oval blamed the gloomy figures on three reasons in its release: "lower volume, higher warranty costs and adverse balance sheet exchange effects."
There were problems of one kind or another in practically every region. North America experienced higher warranty costs than expected, partially due to recalls. The sales volume for the quarter was 665,000 units, versus 725,000 in Q3 2013, and pre-tax results amounted to $1.41 billion versus $2.296 billion last year.
South America and Europe both posted worse pre-tax results than last year. On the bright side, European volume was up slightly to 321,000 vehicles, from 303,000 in Q3 2013. The Middle East and Africa also lost $15 million, but that was an improvement compared to the $25 million loss previously experienced in this region.

Ford Explorer, Expedition next to go aluminum?

Ford made some serious waves when it unveiled the latest F-150. Instead of making its bodywork out of steel, like just about every other truck on the market, Ford went with aluminum. And you can bet the F-150 won't be the last Ford model to go with the lightweight alloy construction, either.
Our compatriots at Edmunds report that Dearborn is considering replacing two of its most popular SUVs with aluminum versions. One candidate is the Expedition, which would make sense considering that the current model (like the two preceding generations and the fullsize Bronco before it) is based on the F-150's underpinnings. Another is the Explorer, which was traditionally based on the Ranger pickup but went with a car-like unibody chassis in its current iteration. If the Explorer does go the way of aluminum, don't expect it to be a part of its very next update, which is likely due too soon for such major changes.
It would stand to reason that, if the Expedition were to go aluminum, so would the next-generation Lincoln Navigator. Ditto the MKT together with the Explorer. But those aren't likely to be the only models in contention for aluminum construction. Like any other automaker, Ford is under pressure to steadily reduce its carbon emissions and improve its fuel economy figures, prompting it to look at a whole range of measures - including more efficient engines, lower rolling-resistance tires, active aerodynamics and lightweight construction. Expect aluminum to play a big part in that equation moving forward.