Se Low Miles 4 Dr Sedan Automatic Gasoline 2.0l Gdi I4 Flex Fuel Engine Oxford W on 2040-cars

Auto blog

NHTSA closes Ford F-150 EcoBoost acceleration probe

Typically when we report on the findings of an investigation from the National Highway Traffic Safety Administration, it's because the government body has discovered a safety issue and prescribed a recall. In this case, however, NHTSA has closed an investigation into a reported performance deficit without ever getting to the recall stage.
The issue revolves around the Ford F-150 - specifically those equipped with the 3.5-liter EcoBoost engine - of which some 360,000 were built in the 2011, 2012 and 2013 model years. After receiving an initial 95 complaints, NHTSA opened an investigation last May - almost a year ago - into the reported issue of reduced engine power under hard acceleration. The agency has since received a total of 525 such complaints, and Ford itself reported receiving over 4,000.
Together, NHTSA and Ford determined that the problem resulted from cylinders misfiring, an issue itself stemming from water getting into the charge air cooler (CAC) mated to the turbochargers. In particularly humid or rainy conditions, water was found to get into the CAC, causing some of the cylinders to misfire, which in turn triggered the ECU to disable those cylinders in order to protect the catalytic converter from damage.

Recharge Wrap-up: Ford's "snowtonomous" Fusion Hybrid, Porsche eyes battery makers

Bosch and Panasonic are vying to be the battery supplier for Porsche's electric sports car based on the Mission E concept. While Bosch's costs may be higher, its solution would offer simpler logistics. Panasonic is already well established as a battery maker, providing the packs for the Porsche car's rival, Tesla. "We're in the final stage of making a decision," says Porsche CEO Oliver Blume, declining to comment on specific manufacturers. Neither Bosch nor Panasonic provided comment. Read more from Automotive News. Renault will supply a fleet of 150 Renault Zoe EVs for a smart solar charging project in Utrecht, Netherlands. The project involves the installation of 1,000 EV chargers powered by 10,000 photovoltaic panels. The Renault Zoes would be used as part of a carsharing program powered by the solar chargers. Renault and its partners will also implement a vehicle-to-grid system to provide energy during peak demand from the solar chargers and connected EVs. Read more in the press release from Renault. Ford has been testing an autonomous Fusion Hybrid prototype that is capable of driving itself in snowy conditions. Ford uses 3D mapping to scan the drive route. Its LiDAR laser mapping can even detect single falling snowflakes. It collects and processes up to 600 gigabytes of data per hour, comparing its environment to saved maps, a process that helps establish location more precisely than GPS. In addition to the LiDAR systems, the car is also equipped with cameras and radar to help it navigate. Eventually, the car could even be able to clean off its sensors when it detects loss of performance from ice and dirt. Read more in the press release below. FROM AUTONOMY TO SNOWTONOMY: HOW FORD FUSION HYBRID AUTONOMOUS RESEARCH VEHICLE CAN NAVIGATE IN WINTER DEARBORN, Mich., March 10, 2016 – Driving in snow can be a slippery challenge, with the potential for one blizzardy gust to white-out your field of view – a situation faced by the majority of people in the United States. So if self-driving cars are to become a reality – and they almost certainly will – they must be able to navigate snow-covered roads. In its quest to bring self-driving vehicles to millions of people around the world, Ford reveals six facts about its technology that allows for a car to drive itself in snow. 1. Mapping the way: Ford first creates high-resolution 3D maps using LiDAR technology to scan the area its autonomous vehicle will later drive in the snow.

Wrap up some fun with Ford's commercial vehicle configurator

Ford has combined multiple steps into one with its commercial vehicle configurator, which allows users to choose, design and place orders for the Transit, Transit Connect, E-Series vans and F-Series Super Duty trucks.
The most interesting part of the new configurator is a fairly robust design tool. Users are able to choose paint color and wrap the vehicle, and then create their own graphics. No materials are needed - Ford provides numerous background textures, text boxes, plenty of shapes and 20 categories of images including floral, construction, plumbing and skylines. Self-created designs or images can be uploaded to the system as well.
We played around with the design tool a bit and uploaded our own image to create the Autoblog Podcast Live van you see here. Feel free to check out the configurator and make your own design.