2013 Ford Focus Se Damaged Salvage Only 3k Miles Economical Runs! Nice Unit L@@k on 2040-cars

Auto blog

Ford Mustang, F-150, Expedition, and Lincoln Navigator recalled

The Basics: Ford will recall 201,900 examples of the 2011-2012 F-150, 2012 Expedition, 2012 Mustang, and 2012 Lincoln Navigator. The affected vehicles have the 6R80 transmission. Of the total, there are 84,000 of them in the United States and 17,900 in Canada. The Problem: The output speed sensor on the vehicle's transmission lead frame can force the gearbox to downshift into first gear. If this happens at high speed, it could cause the rear tires to slide or lock up. Injuries/Deaths: There are no reported injuries, but Ford know of three accidents related to this problem. The Fix: Dealers will update the powertrain control module software to eliminate the problem, and they'll also replace the transmission lead frame. If You Own One: Ford will begin notifying affected customers by mail on May 23. Related Video: FORD MOTOR COMPANY ISSUES THREE SAFETY RECALLS AND TWO SAFETY COMPLIANCE RECALLS IN NORTH AMERICA DEARBORN, Mich., April 27, 2016 – Ford Motor Company is issuing three safety recalls and two safety compliance recalls in North America. Details are as follows: Ford issues safety recall and customer satisfaction program for certain 2011-2012 Ford F-150, and 2012 Ford Expedition, Ford Mustang and Lincoln Navigator vehicles in North America to update powertrain control module software and inspect for certain diagnostic trouble codes Ford is issuing a safety recall for approximately 202,000 2011-2012 Ford F-150, and 2012 Ford Expedition, Ford Mustang and Lincoln Navigator vehicles for a potential issue with the output speed sensor on the vehicle's transmission lead frame. Under certain conditions, the transmission controls could force a temporary downshift into first gear. Depending on the speed of the vehicle at the time of the downshift, the driver could experience an abrupt speed reduction that could cause the rear tires to slide or lock up. This condition could result in loss of vehicle control, increasing the risk of a crash. Ford is aware of three reports of accidents and no injuries related to this condition. Affected vehicles are equipped with a 6R80 transmission and include certain 2011-2012 Ford F-150 vehicles built at Dearborn Truck Plant and Kansas City Assembly Plant, Aug. 19, 2011 through March 9, 2012; 2012 Ford Expedition vehicles built at Kentucky Truck Plant, Aug. 19, 2011 through Dec. 19, 2011; Ford Mustang vehicles built at Flat Rock Assembly Plant, Aug. 19, 2011 through Feb.

UK's Loughborough University improving Ford's 1.0-litre EcoBoost engine

How much does it cost for college students to study zero emissions vehicles? At Loughborough University in the UK, a new Advanced Propulsion Centre (APC) is being built at a cost of a billion pounds ($1.7 billion US). The school has just announce that it will fund a number of grad student positions and is creating a new Chair in Advanced Propulsion Systems, which sounds like a fun job to us. We're weird like that. There will be a total of four professor-type positions in the new Center, including the chair, all focused on teaching students about low-carbon vehicle technologies, specifically electric and hybrid ones. The school is investing 1.5 million pounds ($2.5 million) for the new positions. There is a bigger picture as well, a 26-million pound ($44 million) Advanced Combustion Turbocharged Integrated Variable-valvetrain Engine (ACTIVE) project, which uses funds not only from the school but also from Ford and others. The point of ACTIVE is to study Ford's 1.0-liter EcoBoost engine and "improve further its efficiency and ensure it exceeds 2020 emission regulations." This is already a popular engine for the automaker, and it will need to stay at the bleeding edge of efficiency to remain as important in 2020 as it is today. Loughborough University has been working with automakers on advanced energy technologies for years, for example with Rolls-Royce and fuel cells in 2007 and the Lotus Hotfire engine in 2008. University invests GBP1.5M in advanced propulsion research to advance zero emissions vehicles challenge Loughborough University is investing GBP1.5M over five years in strategic research appointments, inspired by the global challenge to develop the new advanced propulsion technologies required for the move to zero emission vehicles. These appointments reinforce the University's world-class research in low-carbon vehicle technologies, adding new dimensions concerned with electric and hybrid drives. Four appointments will be made, including a Chair in Advanced Propulsion Systems, supported by a number of PhD studentships. The GBP1.5M investment is part of the University's commitment to the recently announced Advanced Propulsion Centre (APC) to support the development of new supply chains for low carbon vehicles. APC is an initiative established by the Automotive Council that will see GBP1 billion of investment from government and industry over the next 10 years.

Ford debuts Fusion NASCAR racer that edges closer to stock [w/video]

The sixth-generation NASCAR Sprint Cup racecar, which will make its competition debut at the 2013 Daytona 500 this weekend, marks the closest thing to a "stock car" that the sport has seen in more than 20 years. No longer using just stickers to distinguish the different brands, the image above shows the lengths NASCAR and automakers went in order to create a racecar design that more closely resembles the individual cars they represent.
Ford, one of the more open and vocal OEMs regarding the Gen6 car's development, is giving us a closer look at its racing version of the Fusion with a pretty revealing side-by-side comparison with last years' racer (click above for an expanded view). Aside from the more realistic front end and production-like body lines, the overall shape, dimensions and proportions have also been designed to give the racecar a more stock appearance. Most of the new racer was designed by the Ford Design Center, which the automaker says was the first time it has been so involved in the design process since the 1960s. Of course, one area the Sprint Cup Fusion really differs from the production Fusion is its Ford Racing 5.8-liter V8 producing around 850 hp. Can you say Fusion SVT?
Scroll down for a quick video from Ford Racing showing a production Fusion morph into a Cup car.