2015 Ford F350 on 2040-cars

Auto blog

Ford Mustang Mach-E fails Sweden's moose test

The infamous moose test has claimed another casualty. This time it's the Ford Mustang Mach-E AWD Long Range, which was tested in an electric four-way alongside the Tesla Model Y, Hyundai Ioniq 5 and Skoda Enyaq iV (an electric utility vehicle closely related to the Volkswagen ID.4 that is sold in the United States). According to the Swedish testers at Teknikens Varld, Ford's electric car not only failed to hit the speed necessary for a passing grade, it didn't perform well at slower speeds, either. To pass the outlet's moose test, a car has to complete a rapid left-right-straight S-shaped pattern marked by cones at a speed of at least 72 km/h (44.7 miles per hour). The test is designed to mimic the type of avoidance maneuver a driver would have to take in order to avoid hitting something that wandered into the road, which in Sweden may be a moose but could just as easily be a deer or some other member of the animal kingdom elsewhere in the world, or possibly a child or car backing into the motorway. Not only is the maneuver very aggressive, it's also performed with weights belted into each seat and more weight added to the cargo area to hit the vehicle's maximum allowable carrying capacity. The Mustang Mach-E only managed to complete the moose test at 68 km/h (42.3 mph), well below the passing-grade threshold. Even at much lower speeds, Teknikens Varld says the Mach-E (which boasts the highest carrying capacity and was therefore loaded with more weight than the rest of the vehicles tested in this quartet) is "too soft in the chassis" and suffers from "too slow steering." Proving that it is indeed possible to pass the test, the Hyundai and Skoda completed the maneuver at the 44.7-mph figure required for a passing grade and the Tesla did it at 46.6 mph, albeit with less weight in the cargo area. It's not clear whether other versions of the Mustang Mach-E would pass the test. It's also unknown if Ford will make any changes to its chassis tuning or electronic stability control software, as some other automakers have done after a poor performance from Teknikens Varld, to improve its performance in the moose test. Related video:

Hurricane Sandy cost automakers 15,000 vehicles, may have ruined up to 200k

Hurricane Sandy was the largest Atlantic storm in US history, and its total economic impact is just now coming into view. According to Automotive News, Toyota, Chrysler, Nissan and Honda are set to scrap around 15,000 new vehicles ruined by the storm. Nissan alone accounts for about 40 percent of those, with 6,000 Nissan and Infiniti models deeded "un-saleable" due to damage. The company saw 56 dealerships shuttered due to the storm, but 51 of those have since reopened.
Toyota, meanwhile, had some 4,000 vehicles at its Newark port facility, and of those, 3,000 may be scrapped. An additional 825 were dealer inventory when they were ruined. Honda and Acura dealers are reportedly sending 3,440 vehicles to the salvage yard. By comparison, Chrysler weathered the storm fairly well with 825 units destroyed, while Hyundai suffered only 400 lost units and Kia scrapped around 200.
As you may recall, Fisker also suffered some losses, and Automotive News reports the manufacturer saw 320 Karma models damaged beyond repair. Ford and General Motors have yet to come up with estimates, and no automaker has commented on the full cost of replacing the vehicles.

Toyota fears supplier pressure in Australia with GM pull out

With Ford and General Motors both announcing an end to production in Australia, the country's auto industry is in a bad way. With the exit of two big players, there's increased concern that a third Australian manufacturer, Toyota, will be forced out, as well.
"We are saddened to learn of GM Holden's decision. This will place unprecedented pressure on the local supplier network and our ability to build cars in Australia," Toyota Australia said in a statement. The GM closure of Holden production will be the direct end to 2,900 jobs, but will also force a dramatic reduction in the size of the country's supplier network, as there will simply be fewer cars to build.
In the same statement, Toyota Australia said it would work with suppliers and local government to figure out whether continuing production Down Under was even feasible. According to Automotive News, a representative for the Australian Manufacturing Workers' Union told reporters it was "highly likely" that Toyota would also close up shop within the next few years.