2006 Ford F-350 Super Duty on 2040-cars

Auto blog

Ford finds flex-fuel engine design plays big role in emissions output

How bad is ethanol for your engine? There's been a lot of debate on this issue as the US considers upping the biofuel content in the national gasoline supply from 10 percent (E10) to 15 percent (E15). The ethanol industry and some scientists say higher ethanol blends show no "meaningful differences" in new engines while the oil industry says ethanol creates health risks. Researchers working at the Ford Research and Innovation Center decided to take a closer look at how a wide range of gas-ethanol blends - E0, E10, E20, E30, E40, E55 and E80 - affected the emissions coming out of a flex-fuel 2006 Mercury Grand Marquis. To see the full report, printed in the journal Environmental Science & Technology, requires payment, but there is an abstract and Green Car Congress has some more details. The gist is that, "with increasing ethanol content in the fuel, the tailpipe emissions of ethanol, acetaldehyde, formaldehyde, methane, and ammonia increased." At least NOx and NMHC emissions decreased. The researchers say that the effects are due to the fuel and "are expected for all FFVs," but that the way that a manufacturer calibrates the engine will affect NOx, THC, and NMOG emissions. It's this last bit that's important, since the researchers found, "Higher ethanol content in gasoline affects several fundamental fuel properties that can impact emissions. ... These changes can have positive or negative effects that can depend on engine design, hardware, and control strategy. In addition to direct emissions impacts, higher ethanol content fuel can also provide more efficient combustion and overall engine operation under part-load conditions and under knock-limited higher-load conditions." So, as we head towards more ethanol in our fuel supply (maybe), manufacturers are going to need to learn how to burn it most efficiently.

Ford Mustang, F-150, Expedition, and Lincoln Navigator recalled

The Basics: Ford will recall 201,900 examples of the 2011-2012 F-150, 2012 Expedition, 2012 Mustang, and 2012 Lincoln Navigator. The affected vehicles have the 6R80 transmission. Of the total, there are 84,000 of them in the United States and 17,900 in Canada. The Problem: The output speed sensor on the vehicle's transmission lead frame can force the gearbox to downshift into first gear. If this happens at high speed, it could cause the rear tires to slide or lock up. Injuries/Deaths: There are no reported injuries, but Ford know of three accidents related to this problem. The Fix: Dealers will update the powertrain control module software to eliminate the problem, and they'll also replace the transmission lead frame. If You Own One: Ford will begin notifying affected customers by mail on May 23. Related Video: FORD MOTOR COMPANY ISSUES THREE SAFETY RECALLS AND TWO SAFETY COMPLIANCE RECALLS IN NORTH AMERICA DEARBORN, Mich., April 27, 2016 – Ford Motor Company is issuing three safety recalls and two safety compliance recalls in North America. Details are as follows: Ford issues safety recall and customer satisfaction program for certain 2011-2012 Ford F-150, and 2012 Ford Expedition, Ford Mustang and Lincoln Navigator vehicles in North America to update powertrain control module software and inspect for certain diagnostic trouble codes Ford is issuing a safety recall for approximately 202,000 2011-2012 Ford F-150, and 2012 Ford Expedition, Ford Mustang and Lincoln Navigator vehicles for a potential issue with the output speed sensor on the vehicle's transmission lead frame. Under certain conditions, the transmission controls could force a temporary downshift into first gear. Depending on the speed of the vehicle at the time of the downshift, the driver could experience an abrupt speed reduction that could cause the rear tires to slide or lock up. This condition could result in loss of vehicle control, increasing the risk of a crash. Ford is aware of three reports of accidents and no injuries related to this condition. Affected vehicles are equipped with a 6R80 transmission and include certain 2011-2012 Ford F-150 vehicles built at Dearborn Truck Plant and Kansas City Assembly Plant, Aug. 19, 2011 through March 9, 2012; 2012 Ford Expedition vehicles built at Kentucky Truck Plant, Aug. 19, 2011 through Dec. 19, 2011; Ford Mustang vehicles built at Flat Rock Assembly Plant, Aug. 19, 2011 through Feb.

2015 Ford Mustang EcoBoost already hitting 12-second quarters

The arrival of a new Ford Mustang means many things to many people, but not least of them is drag racers. The pony car has always been a mainstay of the drag strip, and the Ford Racing team aims to carry that reputation forward with this latest generation. So it cooked up a few basic modifications on three new 'Stangs and headed to the strips at US 131 and Milan Dragway to see what they could coax out of 'em.
Impressively, the 5.0-liter V8 Mustang GT with a few modifications (but no forced induction) managed to clock a quarter-mile time of 11.77 seconds. Another Mustang GT fitted with a supercharger clocked a blistering 10.97 seconds. But just as intriguing was the modified EcoBoost model that, with only four cylinders and 2.3 liters of displacement, still passed the gates in just 12.56 seconds - nearly half a second better than expected. This with modification limited to a new subframe, half-shaft, drive shaft loops, exhaust, engine calibration, slicks, roll cage and bucket seat. Well done, boys.