1997 Ford F350 Xlt, Drw, Crew Cab And 1989 Lance Camper Lc-480 on 2040-cars

Auto blog

Ford EcoBoost successful because of Soviet laser weapons system expert?

Mike Kluzner is a man of many talents. Not only is he the software engineer responsible for fuel system diagnostics for Ford globally, he "got his start designing laser weapon systems capable of disabling the navigation systems of enemy satellites" for the former Soviet Union. Quite a résumé, wouldn't you say?
You may be asking yourself the same question that popped into our minds upon reading about Mr. Kluzner: What do laser weapon systems have to do with Ford and its EcoBoost engines? We'll let the man answer himself. "The same process for analyzing key physical relationships works for what we do today in engine combustion, catalyst chemistry and mechanics," says Kluzner. "These are all part of Ford's software engineering expertise." Who are we to argue?
Ford also employs an engineer who previously designed software to detect damage to the heat tiles on the International Space Station, as well as one who's past work involved particle physics, says the automaker in the press release below. David Bell (pictured above right), global boost system controls engineer for Ford, describes the software running EcoBoost as "the secret sauce" that makes the technology work as the driver intends and demands.

How Ford made its 2015 Ford Mustang safer for toupee wearers [w/video]

Ford is ready to tell the story of its 2015 Mustang Convertible, the can't-miss bits being the easier, quicker and quieter roof operation, a more robust roof build for a coupe-like cabin noise, more trunk space, better visibility and reduced in-cabin buffeting. The top release system has been completely redesigned with a single, center-mounted latch on the windshield frame instead of the dual latches of before. The driver can now release the roof without having to lean over into the passenger space, after which the top goes down fully automatically with the press of a button. Ford doesn't say how long it takes to stow, but it's apparently done in half as much time as before, so figure around 8 seconds.
The roof uses a five-bow structure, with the fabric outer and full inner headliner sandwiching ten millimeters of insulation. Detailing work on the top has eliminated "unsightly folds" in the corners when the roof is up and made it more compact when down; its Z-fold assembly is 6.7 inches lower than before at its highest point when put down. Ford says the new electric drive internals make less noise when in operation, and the fully-finished droptop look is achieved with snap-in caps that flank the rear seating and stow in the trunk when not in use (the outgoing Mustang's top was higher and the front when folded and always looked like it was catching air and creating drag).
The compact roof and newly independent rear suspension setup in back means liberated trunk space, 11.4 cubic feet ready to swallow golf bags and tourist swag. You can read a lot more about it in the press release below, check it out in the short video of running footage and learn about the aerodynamic improvements made to the entire Mustang lineup that decrease drag and increase fuel economy.

2015 F-150 launch to curb Ford profits?

Ford is making a big bet on aluminum with its new 2015 F-150, and it's possible that the decision will hurt the company financially, at least in the short term. After earning a record $8.6 billion in 2013, the Blue Oval does not expect to set another record in 2014. According to Automotive News, that's "largely attributable to F Series," says Bob Shanks, Ford's Chief Financial Officer.
To retool for the new F-150, Ford will idle its Dearborn Truck Plant in Michigan for 11 weeks and the Ford Kansas City Assembly Plant in Missouri for 2 weeks. "3 of the 13 overall weeks occur during what normally is our summer shutdown timeframe," said Mike Levine, Ford Trucks Communication Manager, in an email to Autoblog. The extra 10 weeks will be preparing for the more aluminum-intensive construction for the trucks and will mean over 2 months of no F-150s being made. For comparison's sake, Chrysler boss Sergio Marchionne just confirmed that the 200 plant in Sterling Heights, MI will be down for 30 days to retool for the new model, but obviously there are many more F-150 production variables than for the midsize sedan.
Levine notes that Ford is already running three shifts at both plants, and says the automaker has plans to ensure that there is adequate supply of the full-size pickups during the retooling process. The company does not want to suffer a shortage of the vehicle that accounted for 31-percent of its 2013 US sales and an even bigger percentage of its profits.