2015 Ford F-250 Platinum on 2040-cars

Auto blog

2015 Ford Mustang already under recall, but just 53 units

Ford has issued a small - but significant - recall for one of its spotlight cars: the 2015 Mustang.
The recall affects just 53 cars, with 50 in the United States and three in Canada. Ford said the passenger side safety belt buckle tension sensor may not have been calibrated properly by the supplier. This could lead to "misclassification" of the passenger seat occupant, and could cause the airbag to deploy improperly.
A Ford spokesperson didn't immediately respond to a request for comment. In a statement, the automaker said it is not aware of any accidents or injuries, and dealers will replace the buckle assembly at no cost to customers. The cars affected were built at Flat Rock Assembly Plant in Michigan from Aug. 18 to Oct. 2.

AMC Trans Am Javelin SST, an ultra-rare underdog, is up for auction

Among the rarest of the American muscle cars that went racing in the early Seventies — cars including the Camaro Z/28 and the Boss 302 Mustang — the 1970 AMC Trans Am Javelin SST may be the most hard to find, and among the most valuable. Only 100 units of this unique Javelin were produced, and one of them is up for auction at the Mecum event in Dallas on September 20. The Trans Am Javelin was fashioned in a patriotic livery of tricolor paint — red, white and blue — and arrived after the American Motors Corporation had decided in 1968 to compete in the Trans Am racing series against Ford and General Motors. The company's chief driver, Mark Donohue, would dominate the 1971 season, taking seven wins in his Javelin AMX and that yearÂ’s SCCA Trans-Am Championship. AMC took the trophy with 82 points, well ahead of Ford's 61, Chevrolet's 17 and Pontiac's paltry 7. The example listed for auction came equipped with a 390-cubic-inch V-8 engine with 325 horsepower at 5,000 rpm and 420 pound-feet of torque, power steering and brakes, dual exhaust, BorgWarner four-speed manual transmission and Hurst competition shifter. Its “ram induction system” sealed a chamber around the air filter so that cool air from the functional hood scoop would be funneled into the intake. This JavÂ’s factory price was $3,995 — a mere $32,000 or so in today's money, though it was expensive by the standards of the time. The 100 Trans Ams were among 19,714 Javelin units built in 1970, so they started out rare, and today the surviving examples are highly collectible, if and when they come up for sale. No bid estimate is available yet. Related Video: Motorsports Chevrolet Ford Pontiac Auctions Automotive History Racing Vehicles Classics

Aluminum lightweighting does, in fact, save fuel

When the best-selling US truck sheds the equivalent weight of three football fullbacks by shifting to aluminum, folks start paying attention. Oak Ridge National Laboratory took a closer look at whether the reduced fuel consumption from a lighter aluminum body makes up for the fact that producing aluminum is far more energy intensive than steel. And the results of the study are pretty encouraging. In a nutshell, the energy needed to produce a vehicle's raw materials accounts for about 10 percent of a typical vehicle's carbon footprint during its total lifecycle, and that number is up from six percent because of advancements in fuel economy (fuel use is down to about 68 percent of total emissions from about 75 percent). Still, even with that higher material-extraction share, the fuel-efficiency gains from aluminum compared to steel will offset the additional vehicle-extraction energy in just 12,000 miles of driving, according to the study. That means that, from an environmental standpoint, aluminum vehicles are playing with the house's money after just one year on the road. Aluminum-sheet construction got topical real quickly earlier this year when Ford said the 2015 F-150 pickup truck would go to a 93-percent aluminum body construction. In addition to aluminum being less corrosive than steel, that change caused the F-150 to shed 700 pounds from its curb weight. And it looks like the Explorer and Expedition SUVs may go on an aluminum diet next. Take a look at SAE International's synopsis of the Oak Ridge Lab's study below. Life Cycle Energy and Environmental Assessment of Aluminum-Intensive Vehicle Design Advanced lightweight materials are increasingly being incorporated into new vehicle designs by automakers to enhance performance and assist in complying with increasing requirements of corporate average fuel economy standards. To assess the primary energy and carbon dioxide equivalent (CO2e) implications of vehicle designs utilizing these materials, this study examines the potential life cycle impacts of two lightweight material alternative vehicle designs, i.e., steel and aluminum of a typical passenger vehicle operated today in North America. LCA for three common alternative lightweight vehicle designs are evaluated: current production ("Baseline"), an advanced high strength steel and aluminum design ("LWSV"), and an aluminum-intensive design (AIV).