11 Sd 4x4 6.7 Power Stroke 6" Lift New 20" Rims 37" Tires Net Direct Auto Texas on 2040-cars

Auto blog

Ford issues six recalls covering 101,000 vehicles for multiple issues

Ford is announcing six separate recalls for a variety of issues affecting a dozen models and a total of 100,610 vehicles in North America. However, according to Ford spokesperson Kelli Felker, "None of them have caused accidents or injuries." Half of them cover fewer than 1,000 cars.
The largest recall covers 92,022 North American examples (about 83,250 in the US) of some models of the Ford Taurus, Lincoln MKS, Ford Interceptor, Flex and Lincoln MKT from the 2013 and 2014 model years; the 2012-2014 Edge and the 2014 Lincoln MKX. All of them have a potential issue with the halfshaft on the right side that might not be fully seated and could move outward over time. If it shifts too far, the models may no longer be able to drive, and the condition could also allow the vehicles to roll away, even when in Park. Dealers will inspect the shaft to make sure it's seated and will replace the part if necessary.
The next-largest recall covers 5,264 North American examples (4,867 in the US) of the Ford F59 Commercial Stripped Chassis from the 2011-2014 model years. It's possible that an electrical junction box can corrode in areas with salty roads and short circuit. The problem could potentially cause a fire. Dealers will replace the box with an improved design.

Ford recalls 300,000 Crown Vics over lighting module

The Basics: Ford is recalling 312,814 units of the Crown Victoria and Mercury Grand Marquis sedans from the 2003-2005 model years. They were built at the St. Thomas Assembly Plant between Oct. 3, 2001, and Aug. 2, 2005. Ford says 296,004 of those units are located in the United States, with another 14,714 in Canada and 2,096 in Mexico. The Problem: The solder joints on the lighting control module could crack, depriving the headlamps of the power they need to light the way ahead. That could increase the risk of a crash, particularly at night and in other low-visibility situations. Injuries/Deaths: Ford reports that it is aware of 11 accidents that resulted from the problem, leading to one injury described as "minor." The Fix: The manufacturer is instructing dealers to replace the entire lighting control module. If You Own One: Make sure your headlights are working before getting under way. If they're not, avoid driving under low-light conditions, including at night, in heavy precipitation, or in fog. Ford Issues Three Safety Recalls and One Safety Compliance Recall in North America DEARBORN, Mich., Dec. 22, 2015 – Ford Motor Company is issuing three safety recalls and one safety compliance recall in North America. Details are as follows: Ford Motor Company issues safety recall for certain 2003-2005 Ford Crown Victoria and Mercury Grand Marquis vehicles to replace lighting control module Ford Motor Company is issuing a safety recall for approximately 313,000 2003-2005 Ford Crown Victoria and Mercury Grand Marquis vehicles to replace a lighting control module. The solder joints on the module could crack and interrupt power to the headlamps – increasing the risk of crash at night. Ford is aware of 11 reports of accidents and one report of a minor injury related to this issue. Affected vehicles include certain 2003-2005 Ford Crown Victoria and Mercury Grand Marquis vehicles built at St. Thomas Assembly Plant, Oct. 3, 2001 through Aug. 2, 2005. There are a total of 312,814 vehicles that might be affected in North America, including 296,004 in the United States and federalized territories, 14,714 in Canada and 2,096 in Mexico. Dealers will replace the lighting control module at no cost to the customer. Ford issues safety recall for certain 2016 Ford F-650 and F-750 vehicles to replace rear air brake chamber Ford is issuing a safety recall for 177 2016 Ford F-650 and F-750 vehicles to replace the rear air brake chamber.

Ford dealers offered discounts on tools to fix aluminum

With the introduction of the aluminum-bodied 2015 Ford F-150 (and the likely use of aluminum in future Ford products), Ford is looking to help its dealerships reduce costs related to repairing this more labor-intensive material. Automotive News is reporting that Ford dealers with body shops will require an estimated $30,000 to $50,000 in equipment and training to work on aluminum, and to help alleviate the financial burden of the new F-150, Ford has announced a special 20-percent discount on this equipment.
Dealers will be able to save up to $10,000 on tools such as welders, air-filtration systems and rivet guns and to create aluminum-specific work stations. The new F-150 goes on sale in the fourth quarter, and dealers have until October 31 to take advantage of this deal, according to the report.