1969 F100 2wd Short Bed With A 460 Big Block on 2040-cars

Auto blog

NHTSA investigating 725k Ford, Mercury vehicles for stalling issue

Owners of Ford Escape, Mercury Mariner, Ford Fusion and Mercury Milan models, listen up. According to a report on Automotive News, the National Highway Traffic Safety Administration has opened an investigation into these four vehicles totaling an estimated 725,000 units. The investigation appears to center around a malfunctioning throttle body on non-hybrid models of the 2005-2012 Escape and 2011-2012 Fusion. With Mercury dying off after the 2011 model year, this probe will also apply to the 2005 through 2011 Mariner and the 2011 Milan. There has been some discussion around the Escape stalling issue for some time now, but this investigation appears to be larger in scope than before.
Though not a recall yet, NHTSA's Office of Defects Investigation (ODI) has received 123 complaints of stalling or surging vehicles, while Ford itself has logged 1,472 complaints. The investigation report, which is posted below, seems to indicate that a faulty circuit board for the throttle body could cause the vehicle to go into limp mode, which, according to NHTSA, could cause complaints of both stalling and surging.

Ring Brothers shows 1965-66 Mustang fastback carbon fiber body

We covered one of Ring Brothers' more extreme SEMA builds yesterday, the De Tomaso Pantera-based ADRNLN, but if that well-executed but over-the-top Italian-American exotic is too much for you, then perhaps this Ring Brothers 1965 Ford Mustang fastback with a carbon-fiber body suits your tastes better.
What the performance-parts manufacturer is showcasing with the Mustang is the carbon-fiber body itself, which is fashioned around the 1965-66 fastback. It can be bought from the company and bonded to the skin and unibody as a do-it-yourself project, or you can take your Mustang to Ring Brothers and have the body installed there. The fenders, doors and quarter panels are two-inches wider than stock, and Ring Brothers offers a custom widebody chassis to those who want the complete package.
The show car looks sharp in person lowered on HRE wheels, and we appreciate the bare front end so we can see the supercharged V8 and front coilover suspension, though the details on those performance upgrades are slim. Also note the custom independent rear suspension setup at the rear.

Next Shelby Mustang to wear GT350 nameplate

Earlier this month, rumors started to swirl 'round the web about the next-generation Ford SVT Mustang - the halo version of the all-new 2015 'Stang seen testing in the gallery above. Originally, we heard that the Shelby GT500 moniker would be dumped in favor of "a name you're familiar with," which some sources guessed could mean a return of the Cobra nameplate.
That might not be correct. According to Road & Track, citing a report from Mustangs Daily, the new range-topping Mustang will bring back the Shelby GT350 name - currently used on an aftermarket version of Ford's Pony produced by Shelby American (take a look at our recent Quick Spin of that car). Expect the new GT350 to be quite a bit different than the current GT500 - it will be all motor, using a V8 that's derived from the naturally aspirated 5.0-liter Coyote engine (though it will no doubt have a higher displacement). The GT350 will be a lot more powerful than the next Mustang GT, which is expected to offer something like 450 horsepower, but won't be quite as absurd as the 662-horsepower GT500 we currently enjoy.
The Shelby GT350 will reportedly bow with the rest of the new Mustang range at the 2014 New York Auto Show, which coincides exactly with the original Mustang's debut at the New York World's Fair in 1964. If that seems far out, don't worry, we'll be seeing the rest of the 2015 Mustang range before then, but Road & Track reports that the 2014 Detroit Auto Show stage will be reserved for the reveal of the next Ford F-150 pickup.