2002 Ford Explorer Limited Rust Free on 2040-cars

Auto blog

Ford and Chrysler reducing summer plant shutdowns

Most domestic automaker assembly plants traditionally take a couple of weeks off during the summer. The shutdowns give each plant time for much needed repairs and maintenance, and in some cases, help better align production with demand. Not this year, though, as demand for many models is outstripping what Ford, Chrysler and General Motors plants can produce.
Ford has announced that it will shorten its annual summer shutdown for most North American plants from two weeks to one. The shorter shutdown will increase the carmaker's annual North American production by 40,000 units on top of the 200,000 extra units that it was already planning to produce this year versus last. Automotive News reports that Ford produced 2.8 million vehicles on this continent in 2012, and that output this year has already increased 13 percent through April.
Chrysler, meanwhile, is also operating at full tilt and plans to run some plants through the summer with no shutdown at all. Those not getting a break include Jefferson North where the Jeep Grand Cherokee and Dodge Durango are assembled, Toledo North that will assemble the new Cherokee, and Conner Avenue, home of SRT Viper production. Other assembly plants will be down for a single week, while all of Chrysler's engine and transmission plants except one in Indiana will continue operating with no shutdown this summer.

Ford Fiesta ST GRC Racecar is hungry for podiums in 2013

As we reported earlier, the Chicago showing of this plucky Ford Fiesta ST GRC racer points to bigger and brighter days for Global RallyCross. For the upcoming season, you can expect to see Ken Block and Tanner Foust both driving the Ford racecar, and if last season's results are any indication, you can anticipate quite a few podium appearances, as well.
The Fiesta seen here was built by the Swedes at OlsbergsMSE, and will be driven in anger by Foust in 2013. Modifications are, as you'd expect, extensive, and include an engine, exhaust and braking upgrades, a racing style short-throw shifter and a limited-slip differential. As you can see, the car has been fully stripped out and caged for maximum speed and safety, too.
Refresh your memories with the details of the car, in the press releases below. And if you head out to the Chicago Auto Show this year, don't forget to drop by the Ford stand to have a look.

Toyota fears supplier pressure in Australia with GM pull out

With Ford and General Motors both announcing an end to production in Australia, the country's auto industry is in a bad way. With the exit of two big players, there's increased concern that a third Australian manufacturer, Toyota, will be forced out, as well.
"We are saddened to learn of GM Holden's decision. This will place unprecedented pressure on the local supplier network and our ability to build cars in Australia," Toyota Australia said in a statement. The GM closure of Holden production will be the direct end to 2,900 jobs, but will also force a dramatic reduction in the size of the country's supplier network, as there will simply be fewer cars to build.
In the same statement, Toyota Australia said it would work with suppliers and local government to figure out whether continuing production Down Under was even feasible. According to Automotive News, a representative for the Australian Manufacturing Workers' Union told reporters it was "highly likely" that Toyota would also close up shop within the next few years.