2014 Ford Escape Se on 2040-cars

Auto blog

Ford announces four recalls, 1.4M vehicles affected

Ford is taking a bit of the spotlight away from General Motors, announcing a major group of recall campaigns, covering a total of 1.4 million vehicles built between 2006 and 2013.
Let's start with the big one, which covers the Ford Escape, Mercury Mariner and, according to The Detroit News, Ford-built Mazda Tribute CUVs. 915,216 vehicles are covered, all of which were built in model years 2008 to 2011. 736,000 vehicles are in the US, while Canada then Mexico make up the vast majority of the remainder. The problem is due to an issue with the torque sensor in the steering column, which could lead to sudden power steering failure. Manual steering would still be available, though.
"Dealers will perform one of three service fixes, depending upon what diagnostic codes are shown when the vehicle is taken to the dealer," Ford spokeswoman Kelli Felker wrote to Autoblog in an email. "They will either update software for the power steering control module and the instrument cluster module; replace the torque sensor; or replace the steering column, which includes upgraded power steering control module software."

Watch these videos of an NHRA racer's bodywork blowing off into a crowd

Just a few months ago, fan safety at racetracks was a hot topic following the last-lap NASCAR Nationwide Series crash at Daytona that sent large pieces of racecars into the grandstands injuring 33 fans. Now, a freak incident at a National Hot Rod Association event resulted in a drag racer's bodywork flying into the crowd at the NHRA Four-Wide Nationals in Charlotte over the weekend. The carbon-fiber body of Robert Hight's Ford Mustang funny car blew off toward the end of a run when his engine exploded, but fortunately, the two fans evaluated after the incident were later released without serious injury.
As you can see in the image above, the body flew high into the air before landing on a walkway in front of the grandstands, a bit of happenstance that likely gave most fans enough time and space to move out of the way. Scroll down to watch a couple of videos showing what happened, including one from a fan's perspective that also reveals what appears to be part of the body's metal bracing landing dangerously close to the crowd.

Creations n' Chrome Top Notch Mustang is a one-of-a-kind fox

Is there a cooler car from the 1980s and early 90s to mod than a Fox-body Ford Mustang? No, there isn't. If you disagree with us, we suggest you have a look at this 1990 Mustang Coupe, which just might change your mind. Although considering just how extensively modified this car - the Top Notch Mustang from Creations n' Chrome - is, we wonder just how much Ford is left in this old pony.
It rides on a custom race tube chassis that weighs a scant 700 pounds, while carbon-fiber bits and bobs help lower the overall curb weight to a mere 2,400 pounds. When paired with supercharged, 5.0-liter, Aluminator V8 from Ford Racing, the results are, doubtlessly, exciting. 855 horsepower at the rear wheels and 667 pound-feet of torque are available from that force-fed V8 should be just plenty for this car's intended purpose of running in standing-mile competitions.
The Top Notch Mustang is more extreme than just weight savings and a big engine, though. That 5.0-liter is essentially in what's known as a front-mid layout - where the engine is actually behind the front axle. In this case, the 5.0-liter V8 is 17 inches further back than a factory Fox-body, for better weight distribution. As a result, the cabin has been completely overhauled. An SLA front suspension, wheels from HRE, Wilwood brakes and Sparco interior items round out the extensive list of mods.