Ford E-series Van E 150 Wheelchair Handicap 2009 Econoline Mobility Clean Conv on 2040-cars

Auto blog

Aluminum lightweighting does, in fact, save fuel

When the best-selling US truck sheds the equivalent weight of three football fullbacks by shifting to aluminum, folks start paying attention. Oak Ridge National Laboratory took a closer look at whether the reduced fuel consumption from a lighter aluminum body makes up for the fact that producing aluminum is far more energy intensive than steel. And the results of the study are pretty encouraging. In a nutshell, the energy needed to produce a vehicle's raw materials accounts for about 10 percent of a typical vehicle's carbon footprint during its total lifecycle, and that number is up from six percent because of advancements in fuel economy (fuel use is down to about 68 percent of total emissions from about 75 percent). Still, even with that higher material-extraction share, the fuel-efficiency gains from aluminum compared to steel will offset the additional vehicle-extraction energy in just 12,000 miles of driving, according to the study. That means that, from an environmental standpoint, aluminum vehicles are playing with the house's money after just one year on the road. Aluminum-sheet construction got topical real quickly earlier this year when Ford said the 2015 F-150 pickup truck would go to a 93-percent aluminum body construction. In addition to aluminum being less corrosive than steel, that change caused the F-150 to shed 700 pounds from its curb weight. And it looks like the Explorer and Expedition SUVs may go on an aluminum diet next. Take a look at SAE International's synopsis of the Oak Ridge Lab's study below. Life Cycle Energy and Environmental Assessment of Aluminum-Intensive Vehicle Design Advanced lightweight materials are increasingly being incorporated into new vehicle designs by automakers to enhance performance and assist in complying with increasing requirements of corporate average fuel economy standards. To assess the primary energy and carbon dioxide equivalent (CO2e) implications of vehicle designs utilizing these materials, this study examines the potential life cycle impacts of two lightweight material alternative vehicle designs, i.e., steel and aluminum of a typical passenger vehicle operated today in North America. LCA for three common alternative lightweight vehicle designs are evaluated: current production ("Baseline"), an advanced high strength steel and aluminum design ("LWSV"), and an aluminum-intensive design (AIV).

How Ford made its 2015 Ford Mustang safer for toupee wearers [w/video]

Ford is ready to tell the story of its 2015 Mustang Convertible, the can't-miss bits being the easier, quicker and quieter roof operation, a more robust roof build for a coupe-like cabin noise, more trunk space, better visibility and reduced in-cabin buffeting. The top release system has been completely redesigned with a single, center-mounted latch on the windshield frame instead of the dual latches of before. The driver can now release the roof without having to lean over into the passenger space, after which the top goes down fully automatically with the press of a button. Ford doesn't say how long it takes to stow, but it's apparently done in half as much time as before, so figure around 8 seconds.
The roof uses a five-bow structure, with the fabric outer and full inner headliner sandwiching ten millimeters of insulation. Detailing work on the top has eliminated "unsightly folds" in the corners when the roof is up and made it more compact when down; its Z-fold assembly is 6.7 inches lower than before at its highest point when put down. Ford says the new electric drive internals make less noise when in operation, and the fully-finished droptop look is achieved with snap-in caps that flank the rear seating and stow in the trunk when not in use (the outgoing Mustang's top was higher and the front when folded and always looked like it was catching air and creating drag).
The compact roof and newly independent rear suspension setup in back means liberated trunk space, 11.4 cubic feet ready to swallow golf bags and tourist swag. You can read a lot more about it in the press release below, check it out in the short video of running footage and learn about the aerodynamic improvements made to the entire Mustang lineup that decrease drag and increase fuel economy.

Lincoln MKC recalled because start button located too close to touchscreen [UPDATE]

UPDATE: Ford spokesperson Kelli Felker responded to our questions and let us know that the fix for the push-button start on the 2015 MKC has the switch moved to the top of the of the column of gear shift buttons instead of the bottom. Owners should be notified about both campaigns "toward the end of February." After massive campaigns from General Motors and to fix Takata airbag inflators, 2014 will undoubtedly go down as The Year Of The Recall. And with little time to spare, Ford is getting in just under the wire to adding two more to its yearly total. The larger of the campaigns is actually one of the most bizarre campaigns we've heard of all year. Lincoln is recalling 13,574 units of its 2015 MKC compact crossover in North America to move the location of the push-button ignition switch on the dashboard. According to the automaker's announcement: "Due to the switch's close proximity to other controls, occupants are inadvertently shutting off the engine while driving." The button is located near the bottom of the touchscreen, which can apparently make it possible to hit by mistake. Back when Autoblog first drove the new MKC in June, we came away very impressed, but noted: "... we're still not completely sold on the aforementioned pushbutton transmission selector ... it still seems somewhat gimmicky and it can't be operated by feel alone, as you might when shifting a traditional console-mounted lever from Park to Drive." According to Lincoln, there have been no reported accidents or injuries stemming from this button misapplication. Of the affected vehicles, there are 11,144 in the US, 2,033 in Canada and 397 in Mexico. To fix the problem, dealers are moving the button to a different location and reprogramming the powertrain control module. According to Automotive News, models built since September already have a different layout. The change was reportedly done to match the rest of the Lincoln lineup. The second recall covers 12,205 units of the 2014 Ford Escape (2015 model year pictured below) and 2015 Lincoln MKC in North America because of a problem with nickel plating on the fuel pump. The issue can cause the pump to seize, which can cause the crossovers not to start or stall while driving. The automaker is not aware of any accidents or injuries related to this fault. Dealers are replacing the fuel deliver module to fix the situation. Of the affected vehicles, there are 9,038 in the US, 3,074 in Canada and 93 in Mexico.