2002 Ford Crown Victoria 4.6l V8 6-pass Cruise Ctrl 29k Texas Direct Auto on 2040-cars

Auto blog

Ford, GM to collaborate on 9- and 10-speed transmissions

Back in October, there were reports that General Motors and Ford Motor Company were hard at work co-developing new nine- and ten-speed automatic transmissions, and now both automakers have confirmed this joint operation. While there are no specific vehicles mentioned to receive either transmission, a collaborative press release issued by GM and Ford mention that the transmission will be designed for front- and rear-wheel-drive cars, crossovers, trucks and SUVs.
These aren't the first powertrain components developed jointly between these cross-town rivals, either. The six-speed automatic currently used in vehicles like the Ford Edge, Ford Fusion, Chevrolet Cruze and Chevrolet Equinox was engineered in a similar fashion. As is the case with this existing transmission, both automakers will assist in the design, development and testing of the new transmissions, but each will build its own units in its own factories. Scroll down for the official press release.

Ford's J Mays feels vindicated by Fusion reception

It's hard to think back now, but the same man overseeing the design of the 2013 Ford Fusion also presided over a rather lackluster period in Ford design, highlighted by vehicles like the Five Hundred and Freestyle. With the redesigned Fusion receiving high praise, J Mays tells Automotive News that he feels vindicated from criticisms suggesting he's not a daring enough designer.
When Mays took over as lead of design in 1997, he admits to having quite an ego ("My head would barely fit through the door some days. I've long since gotten over myself") and the workload to match. With the Blue Oval's portfolio full of premium brands like Aston Martin, Jaguar, Land Rover and Volvo at that point, along with the bread-and-butter Ford, Lincoln and Mercury models, Mays certainly had quite the challenge.
It was in the mid-2000s that Mays took over just the premium brands, and took on the new title of Chief Creative Officer. At the time, Mays endured some criticism for looking backwards to retro styling, rather than setting a new standard for American car design - criticism that Mays says he is free from with the all-new Fusion.

Ford F-Series Super Duty prototype reduced to smoldering mess of aluminum and steel [UPDATE]

The most important bit of information you need to know after looking through our high-res gallery of images depicting a prototype 2016 Ford F-Series Super Duty pickup truck burning to the ground is that nobody was hurt. There were two engineers inside the vehicle when it caught fire, and both exited to safety.
That's the good news. The bad news is that the truck, which appears to have been testing in Death Valley, appears to be a total loss, minus, of course, whatever information Ford can glean from the conflagration - particularly tracing it back to its root cause. Besides that, we're also expecting the body of the next Super Duty to be hewn from aluminum, as is the case with its smaller brother, the brand-new F-150. Note the little aluminum droppings littering the roadway as apparent proof of that.
Our spy photographers report that it took just 21 minutes for the F-Series Super Duty to burn completely to the ground. The fire appears to have started in the driver-side front wheel well, spreading to engulf the entire front end in three minutes. We can't confirm the source of the blaze, but we're curious if the car's black vinyl cladding, meant to obscure the secrets within, contributed to the fire.