Find or Sell Used Cars, Trucks, and SUVs in USA

1974 Ford Bronco 4x4 on 2040-cars

US $13,500.00
Year:1974 Mileage:0 Color: Green /
 Black
Location:

Belmont, California, United States

Belmont, California, United States
Advertising:
Transmission:Automatic
Vehicle Title:Clear
Engine:5.0L 302Cu. In. V8 GAS Naturally Aspirated
For Sale By:Private Seller
Body Type:Sport Utility
Fuel Type:GAS
VIN: U15GLS9760 Year: 1974
Make: Ford
Warranty: Vehicle does NOT have an existing warranty
Model: Bronco
Trim: Base Sport Utility 2-Door
Options: 4-Wheel Drive, Convertible
Drive Type: U/K
1974 Ford Bronco 4x4: Ford 1974
Mileage: 0
Exterior Color: Green
Number of Cylinders: 8
Interior Color: Black
Condition: Used: A vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections. ... 

For Sale

1974 Ford Bronco 4x4
Clean Title (NON OP)

Milage: 73477 on speedo
0 miles on engine & transmission

Driven up and down the block to keep the juices flowing
To many projects not enough time

DONE
-Rebuild Engine
-Rebuild Transmission
-Master Cylinder power brake unit NEW
-Steering Colum in engine compartment 
-Emergency cable extension NEW
-Dash pad NEW
-Driver and passenger arm rest pads NEW
-Carpet kit NEW
-Fuel sending units for both tanks NEW
-NEW brake shoes on all four
-NEW brake cylinders on fronts
-Radiator and Fuel tanks flushed RECENTLY
-Electricle fuel pump or manual YOUR CHOICE
-35" tires 100% tread
-3" Frame Lift
-5" Body Lift
-Shocks and Springs NEW
-Edelbrock 4 barrel carb
-Edelbrock air gab intake
-Headers
-Dual Exhaust
-Custom Tire & Dual 5 Gallon Fuel tank gate
-Power steering box rebuilt
-Some paint done ( on hard top & engine hood)

NOT DONE
-Finish paint
-Replace driver door lock
-Replace hard top re-door latch 
-Heavy duty power steering pump needed for 35" tires(Stock pump underpowered)
-Door seals needed
-Some rust on tailgate latch
-Driver and passenger floor pans needed(have covered with sheet metal inside & out)
-Driver and passenger seats are worn but are still in good condition
-NO REAR SEAT
-Passenger seat belt needs to be replaced
-Rebuild Fuel line valve below driver chair
-Re-connect electrical at fuel tanks
-Ignition switch works with STARTER BUTTON
-ALL electrical works(just needs minor repair)
-SOME MINOR corrosion (Due to age of vehicul) 

Auto Services in California

Zenith Wire Wheel Co ★★★★★

Automobile Parts & Supplies, Wheels, Tire Dealers
Address: 818 Cristich Ln, Brookdale
Phone: (831) 425-7770

Yucca Auto Body ★★★★★

Automobile Body Repairing & Painting, Truck Body Repair & Painting
Address: 56132 29 Palms Hwy, Pioneertown
Phone: (760) 365-9410

World Famous 4x4 ★★★★★

Auto Repair & Service, Automobile Restoration-Antique & Classic
Address: 75 E Palm Ave, Alhambra
Phone: (818) 816-0121

Woody`s & Auto Body ★★★★★

Automobile Body Repairing & Painting, Truck Body Repair & Painting
Address: 22920 Lockness Ave, East-Rancho-Dominguez
Phone: (310) 784-3820

Williams Auto Care Center ★★★★★

Auto Repair & Service, Automobile Inspection Stations & Services, Auto Oil & Lube
Address: 18380 Highway 12, Sonoma
Phone: (707) 996-1056

Wheels N Motion ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Tire Dealers
Address: 961 E Holt Ave, Chino
Phone: (909) 622-1232

Auto blog

Next Ford Mustang to drop 400 pounds

Thu, 15 Aug 2013

The Ford Mustang is already the lightest of the current crop of muscle cars, at around 3,600 pounds for a GT coupe with the six-speed manual transmission. That's almost 260 pounds less than a Chevrolet Camaro SS and about 450 pounds less than a Dodge Challenger R/T, which means the Mustang has a pretty big advantage when it comes to handling, braking, accelerating and economy. More good news: The next Mustang will be even lighter.
According to a report from Edmunds, the sixth-generation Mustang, which is set to debut at the 2014 North American International Auto Show, will shed an additional 400 pounds of body fat. That 11-percent weight reduction will be thanks to lightweight materials, with a particular focus on using stronger, but less material in construction. Aluminum will feature heavily, but Edmunds' inside source warns that there is "nothing terribly exotic" coming to the original pony car.
The other big news is that the new Mustang will be smaller overall. It's going to be 15-inches shorter than the 188.5-inch Mustang on sale today, while it'll also be 6.5 inches narrower. Shorter overhangs, both in the front and rear, are also good signs for those that want an agile Mustang.

Here's what the UAW will be angling for in next year's contract negotiations

Mon, Dec 15 2014

The United Auto Workers union is about to enter a new round of negotiations with the Detroit Three automakers, and this time, the focus is on the end of the two-tier wage system. Introduced in 2007, the two-tier wage system was enacted to allow General Motors, Ford and Chrysler to categorize its hourly employees under two categories: Tier 1 for veteran employees with full rights and benefits, and Tier 2 for short-term or entry-level employees compensated under a different schedule. The idea was that the system would permit the automakers to invest more in their plants and hire new employees as part of their respective recovery plans without being saddled with all the costs associated with hiring full-time employees. Now that the automakers are (more or less) back on their proverbial feet, however, the UAW wants to see an end to the two-tier system, and will likely make that a center-point of its negotiations next year to replace the current arrangement that is scheduled to end in September 2015. Not all members of the UAW will necessarily be interested in ending the two-tier system, however. According to The Detroit News, some Tier 1 workers may be more interested in negotiating a raise in their hourly rate – something which they haven't received in almost a decade. Tier 2 workers, meanwhile, may be more motivated to keep the tiered system in place, as their arrangement includes provisions for profit-sharing payments that have seen the automakers pay out billions to so-called short-term employees in lump-sum payments. Reconciling the two competing demands from two categories of union members and presenting a united front in negotiations may prove the biggest challenge for the UAW's new president, Dennis Williams. And with the right to strike – something which was suspended during the last round of negotiations in 2011 – the union has a bigger bargaining chip in its pocket.

First 1K next-gen Mustangs to carry 2014 1/2 model year?

Thu, 18 Jul 2013

A new report from Mustangs Daily, citing insider sources at Ford, tells us that the Blue Oval will produce 1,000 next-generation Mustangs with the model year designation of 2014 ½, to celebrate the 50th anniversary of the storied marque. The commemorative half-year designation is a rumor that's been swirling in Mustang forums for quite some time now, and seems more plausible than ever with this most recent report. Certainly it's not far-fetched to believe that Ford will want to make a big deal of the golden anniversary for its most-loved model.
The story (compiled by Drew Phillips, who runs the aforementioned Mustang site when he's not directing the photography on these pages) goes on to say that the limited-run cars will be the first built on the new Mustang platform internally known as S550 (and spied testing in the attached gallery). Each car is said to carry a "special" VIN and build number, though no performance upgrades versus the 2015 cars to follow are in the works. A collector's dream then, rather than a weekend racer's.