2005 Dodge Viper Srt-10 on 2040-cars

Auto blog

Chrysler says its 8-speed transmissions will save 700 million gallons

Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.

Fiat Chrysler expands Takata airbag recall to 3.3M vehicles

Fiat Chrysler Automobiles is expanding its recall of vehicles equipped with Takata airbags, moving beyond Florida, Hawaii, Puerto Rico and the US Virgin Islands to the greater US, as well as Mexico, Canada and beyond. The affected vehicles, some 3.3 million in total, were built between 2004 and 2007, with many models, including the Dodge Ram 1500, 2500 and 3500, Durango and the Chrysler 300, having been affected by Chrysler's previous recall. Despite the somewhat alarming nature that comes with a recall of this many vehicles, it seems that Chrysler is moving more out of an abundance of caution (and federal pressure) than anything else, saying: "Neither FCA US, nor Takata Corporation, the supplier, has identified a defect in this population of inflators. These components also are distinct from Takata inflators cited in fatalities involving other auto makers. More than 1,000 laboratory tests have been performed on these components. All deployed as intended, but FCA US continues to study the suspect inflators, which are not used in the Company's current production vehicles." Owners of affected vehicles will be notified and asked to report to dealers for a free replacement driver's side airbag. Scroll down for the official press release from FCA. Statement: Global Air-Bag Inflator Replacement December 19, 2014 , Auburn Hills, Mich. - FCA US LLC will replace driver's-side air-bag inflators in an estimated 3.3 million older-model vehicles worldwide, in an expansion of an ongoing regional field action. Neither FCA US, nor Takata Corporation, the supplier, has identified a defect in this population of inflators. These components also are distinct from Takata inflators cited in fatalities involving other auto makers. More than 1,000 laboratory tests have been performed on these components. All deployed as intended, but FCA US continues to study the suspect inflators, which are not used in the Company's current production vehicles. Outside of Florida, one of the areas covered by the original action, no FCA US vehicle has been linked to an air-bag deployment of the type that has raised public concern. Nevertheless, the Company is replacing the Takata components tied to that concern. FCA US is aware of one related injury involving one of its vehicles, an older-model sedan. It occurred in a southern Florida region marked by persistent, high, absolute humidity – a condition believed to be a contributing factor in the air-bag deployments under investigation.

FCA seeks partner to keep building Dodge Dart, Chrysler 200

Mere weeks after FCA announced it was shutting down production of the Dodge Dart and Chrysler 200, new hope emerges to give the sedans a stay of execution. Speaking at the Geneva Motor Show last week, Sergio Marchionne said that the company was looking for a partner "who is better at it than we are and who has got capacity available" in order to continue building the models on its behalf. "There are discussions going on now," said Marchionne, according to Motor Trend. "I think we will find a solution. We continue to talk. It's both a technical solution and an economic one. We need to find a solution that works economically." Contracting vehicles to be manufactured offsite is more common practice among European automakers than it is with American ones. Chrysler's former patron Mercedes, for example, has the G-Class built for it by Magna Steyr in Austria, the A-Class by Valmet in Finland, and the R-Class by AM General in Indiana (even though it's no longer sold in the US). This arrangement would, on the surface at least, appear more similar to the deal that Toyota struck with Mazda to build the Scion iA, drawing on the contractor's expertise and capacity to build the small sedan on the client company's behalf. Only rather than basing a new model on one of the partner's existing ones, this deal would ostensibly continue building FCA models on FCA platforms using FCA components. We'll have to wait to find out with whom FCA strikes up the manufacturing deal, but we wouldn't be surprised to see Marchionne turn to a partner he already knows. The company is, after all, at the center of an intricate web of joint ventures and manufacturing contracts. The Fiat 124 Spider, for example, is built by Mazda. The Fiat Sedici that preceded the 500X was built by Suzuki. Models like the Dodge Stealth and Eagle Talon were built in Illinois at the Diamond-Star Motors joint venture before Mitsubishi took it over altogether. And Dodge continued selling the Mercedes-made Sprinter long after DaimlerChrysler split. The Ram ProMaster, though built by FCA in Mexico for the North American market, stems from a partnership in France with PSA Peugeot Citroen. And the ProMaster City is built in a joint-venture plant in Turkey, from which it's also sold by GM as an Opel in Europe and a Vauxhall in the UK. With all those deals coming and going, after all, what would one more add to the complexity?