2003 Dodge Ram 1500 Ideal High Top Conversion Van , Outstanding Condition!! on 2040-cars

Auto blog

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

Mopar '13 Dart priced from $25,485*

For the past few years, Chrysler's Mopar in-house tuning division has created its own one-off versions of several cars in the automaker's portfolio, including the Mopar '10 Challenger, Mopar '11 Charger and Mopar '12 300. For 2013, the black-and-blue up-do has been given to the new Dart compact, and Chrysler has announced that the limited-edition sedan is now available for order, priced from $25,485, not including *$995 for destination.
Like previous Mopar edition vehicles, the Dart is painted in a signature Pitch Black exterior with an offset blue racing stripe. The sedan sits seven millimeters lower to the ground and gets visual add-ons like a chin spoiler, decklid spoiler and rear diffuser, along with gloss black 18-inch alloy wheels.
Performance wise, the Dart's 1.4-liter MultiAir inline four-cylinder engine remains, producing 160 horsepower and 184 pound-feet of torque, mated to a six-speed manual transmission. The Mopar car gets a sport-tuned exhaust system along with revised power steering calibration and beefier brakes.

Chop the top of your new Dodge Viper for $35,000

We have good news, and we have bad news. First, the good: It's now possible to get a brand-new Dodge Viper roadster, which is nice, considering we're in the dead of summer and many of us like wind-in-the-hair motoring. Now, the bad: This is not a factory option from the automaker, instead coming courtesy of an aftermarket company called Prefix Performance, and that means it's going to cost you some serious coin.
Called Medusa, this drop-top Viper was created without the knowledge or consent of Dodge, but that's probably fine because Prefix works with the automaker already for the final preparation of the American supercar, including paint. According to the company, the current, fifth-gen Viper was built with a convertible version in mind, so no chassis strengthening is required. From the looks of the somewhat grainy photos available, the conversion appears of very high quality.
Want one? Well, that means you're going to need to procure a Viper - Prefix has 10 units ready for transformation as it stands - and that's going to cost at the very least $102,485. Then, you'll need to write a check for an additional $35,000 for Prefix to surgically remove the car's roof. Thing is, for that kind of cash, a prospective owner could buy, among other very nice options, a Viper hardtop and a loaded Miata, or a Corvette Stingray convertible and several pockets full of change. Or, perhaps a new Viper hardtop and a used, first-gen Viper convertible?