07 Dodge Dually Bagged On 24s Custom Truck on 2040-cars

Auto blog

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

NHTSA investigating Ram 1500 models for rear differential failure

The National Highway Traffic Safety Administration is investigating Fiat Chrysler Automobiles and its Ram brand following a number of reports regarding the 2005 Dodge Ram 1500 pickup. According to 15 consumer complaints, the trucks' rear differential locked up while in other cases, the driveshaft separated at its connection to the diff.
Nearly half of the reports claim the truck was traveling at or above 50 miles per hour, while two consumers reported that the diff lockup/driveshaft separation sent their pickups into a spin. Most troubling, though, is that consumers reported little to no sound indicating there was a problem with their truck.
We reached out to Ram for additional information, such as how many vehicles may be affected or what equipment might be fitted that could cause the issue. Unfortunately, the company wasn't willing to elaborate on specifics.

Chrysler recalls small number of 2013-2014 cars and trucks over engine debris

Chrysler is recalling a small number cars over issues with their 2.4-liter four-cylinder engines. The recall, which affects 522 examples of its 2013 Dodge Avenger and Chrysler 200 models, as well as 2014 Jeep Compass and Patriot CUVs has to do with potential debris in the balance shaft bearings.
The abrasive stuff can cause the oil pressure to drop, which could lead to the engine stalling or outright failure. This situation could at best leave drivers stranded and at worst lead to a crash.
Chrysler will begin notifying owners, who will need to report in to have the balance shaft module replaced. All repairs are naturally free of charge. Scroll down for the bulletin from NHTSA.