2004 Dodge Slt on 2040-cars

Auto blog

Watch 1,414-hp worth of Dodge Challenger SRT Hellcat do stereo burnouts

When Dodge announced that the 2015 Dodge Challenger SRT Hellcat would produce 707 horsepower and 650 pound-feet of torque from its supercharged 6.2-liter V8, automotive enthusiasts were shocked. The company had promised us that it would be powerful, but no one expected for the muscle car to post even larger numbers than the range-topping Viper.
Car and Driver recently got ahold of two new SRTs and decided that the only proper way to show them off was by lighting up the rears in stereo. With a combined 1,414 horsepower, the pair of them make burnouts from the Hellcat V8 look as easy as breathing. The tires start spinning at the slightest provocation and just don't stop. If you buy one of these, it looks like you and the employees at the local tire store are going to be on a first name basis.
Scroll down to watch these two Hellcats to lay down enough smoke to alert the local hook and ladder trucks.

2014 Dodge Journey Crossroad

Watchers of the auto industry will notice a theme among the formerly bankrupted American automakers, General Motors and Chrysler. There are the post-bankruptcy vehicles, and the pre-bankruptcy vehicles. The former, in the case of Chrysler, include the Jeep Grand Cherokee, as well as the 200 and 300. For GM, there's the Cadillac ATS, Chevrolet Impala and Buick Encore, among others. These vehicles have the freshest styling, with sharp exteriors and well-crafted interiors, as well as advanced powertrains and well-sorted chassis.
As for the pre-bankruptcy vehicles, they tend to be easy to spot. Most suffer from inferior driving dynamics, cheaper interiors, poorer fuel economy and often homely looks (we know, there were some decent cars before the bankruptcy, but they were pretty heavily outweighed by the bad ones). Think late, last-generation Chevrolet Impala or Chrysler 200. Increasingly, though, we're seeing vehicles that split the balance between pre- and post-bankruptcy. Vehicles like the Dodge Journey.
The Journey debuted in 2007 as a 2008 model year vehicle, meaning it should fall into the latter category. But heavily breathed upon in 2011, it now enjoys a new, 3.6-liter Pentastar V6, a big, critically acclaimed touchscreen display and in the case of today's tester, a new-for-2014 Crossroad spec.

Chrysler says its 8-speed transmissions will save 700 million gallons

Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.