*2008*ram 2500*4x4*quad Cab*cummins Turbo Diesel*auto*8' Bed*one Owner*65k Miles on 2040-cars

Auto blog

Corvette Z06 and Viper TA square off at the strip

There are many long-standing grudge matches among automobiles: 911 vs GT-R, Mustang vs Camaro, Ferrari vs Lamborghini... but as far as high-end American metal goes, it doesn't get much more legendary than Viper vs 'Vette. So after Chevy released the new Corvette Z06, we knew it was only a matter of time before it would have to square off against the Viper TA. And what better place to pit these two parallel pillars of American performance than on the drag strip? Fortunately that's just what we have here. In one corner, the 2014 Dodge Viper TA, with its 8.4-liter V10 pumping out 640 horsepower and 600 pound-feet of torque. In the other, the 2015 Chevrolet Corvette Z06, the supercharger on its 6.2-liter V8 more than making up for the discrepancy in displacement and cylinder count to produce 650 hp and just as much torque. But numbers don't tell the whole story, so watch the video clip to see which reaches the end of the quarter-mile first. News Source: To the Floor via YouTubeTip: James Chevrolet Dodge Videos drag race chevy corvette z06 quarter mile drag strip srt viper ta

VLF Force 1 V10 is a rebodied Viper priced like a Lamborghini

It would appear that Henrik Fisker is done with hybrids. His latest project, called the Force 1, packs an oversized V10 engine with no electric assist in sight and all the environmental credentials of a herd of flatulent cattle. Alongside the Karma-based, Corvette-powered Destino, the Force 1 is the second product from VLF Automotive. Fisker has taken partnership in the new firm as chief designer alongside chairman Bob Lutz and CEO Gilbert Villarreal. The company isn't saying explicitly what the Force 1 is based on, but it doesn't take a CSI team to trace its roots back to the Dodge Viper. Never mind that it's being built in Auburn Hills – the same Detroit suburb where Chrysler is headquartered – or that it was jointly developed by Fisker and professional Viper racer and dealer Ben Keating. It also happens to be powered by an 8.4-liter V10, and there aren't many of those kicking around the industry. Instead of the Viper's 645 horsepower and 600 pound-feet of torque, the Force 1's ten-cylinder engine is optimized to deliver 745 hp and 638 lb-ft. That, according to VLF, is enough to send the coupe rocketing to 60 in 3.0 seconds flat, covering the quarter-mile in under 11 seconds on its way to a top speed of 218 miles per hour. The power is transmitted to the Pirelli PZero rubber through a six-speed manual, but VLF says it will fit it with an automatic at the customer's request. Around that massive engine and two-seat cockpit, Fisker designed a new shape that, for better or for worse, looks way more aggressive than the Viper's. The Force 1's proportions are tellingly super-snake, but the curves are replaced by some very angry-looking angles and vents. Its head- and taillights are ultra thin, and the deep-dish, split-four-spoke wheels seem to visually split the difference between the three-spoke wheels on the original Viper and the five-spoke alloys it wears today. If you doubted the Force 1's origins before, the interior ought to give it away, with its wide tunnel and familiar surfaces. Only VLF has refinished it in leather, suede, and Alcantara, all diamond stitched with contrasting thread to help position this as a more luxurious prospect than the Dodge. It even fit between the seatbacks place for two champagne bottles that we hope nobody would consider consuming before trying to handle that much power. Of course, none of this will come cheap.

Chrysler Recalling 700k Vehicles For Ignition Switch Woes

General Motors isn't the only automaker with ignition switch problems. Chrysler is fighting it too and is now announcing a recall of 695,957 examples worldwide of the Chrysler Town & Country and Dodge Grand Caravan minivans from the 2008-2010 model years, plus the 2009-2010 Dodge Journey. According to a statement from Chrysler, the models have a bad wireless ignition node detent ring in the ignition switch, making it possible for drivers to appear to have the key in the "Run" position but for the spring not to fully engage. It can then slip back to the "Accessory" position and shut the car off. If this happens, the vehicle loses power steering, brake boost and the airbags. There is some disparity about the number of vehicles affected under this recall. In its statement, Chrysler claims that it covers 525,206 vehicles in the US, 102,892 in Canada, 25,591 in Mexico and 42,268 elsewhere. However, the recall announcement posted by The National Highway Traffic Safety Administration lists an estimated 438,109 vehicles in the US. Chrysler spokesperson Nick Cappa told Autoblog via email that the reasoning for the different figures "will become clear at a later date." To fix the problem, Chrysler will install a new detent ring in the vehicles. It will begin contacting owners soon, and obviously the repair will be free of charge. This isn't the first time this problem has cropped up in these models. Chrysler issued a recall for 248,437 vehicles in 2011 for certain 2010 model year examples. A few weeks ago, NHTSA also began investigating the 2008-2010 model years of the affected models for ignition switch problems. At this time, it's not clear whether that evaluation and this campaign are linked. Chrysler told Autoblog that it has no reports of injuries related to the problem. Scroll down to read the company's statement and the NHTSA recall report. Statement: Expansion of Wireless Ignition Node (WIN) safety recall July 1, 2014 , Auburn Hills, Mich. - Out of an abundance of caution, Chrysler Group is expanding a previous safety recall to install a more robust WIN module detent ring. A previous recall in 2010 included 196,000 Chrysler Town & Country, Dodge Grand Caravan and Dodge Journey vehicles built August 2, 2009 through June 17, 2010. The expansion includes an additional 695,957 vehicles manufactured January 29, 2007 through August 1, 2009.