Trx Ethanol - Ffv 5.7l Cd Rear Wheel Drive Tow Hooks Power Steering Abs A/c on 2040-cars

Auto blog

NHTSA investigating power modules on Chrysler Group SUVs and minivans

The Center for Auto Safety is officially petitioning the National Highway Traffic Safety Administration to begin scrutinizing alleged problems with the totally integrated power module (TIPM) on about 24 Chrysler Group SUVs and minivans. The advocacy group claims that the part's failure can cause affected vehicles to stall or not start at all. NHTSA is still looking into the accusations and deciding whether a full investigation is actually warranted.
The CAS petition claims at least 70 TIPM failures, but according to NHTSA, six of the complaints are for models that don't have the modules. In 34 of the reported cases, the vehicles refused to start, and in 17 of them the engine stalled. There were also two allegations of smoke and one of a fire. However, none of these affected airbag deployment or resulted in a crash.
This petition isn't the first TIPM-related problem for Chrysler Group. A recent report in the New York Times alleged that it found 240 complaints potentially related to the issue on NHTSA's website alone. In September, the automaker also recalled 230,760 examples worldwide (188,723 in the US) of the 2011 Jeep Grand Cherokee and Dodge Durango replace the fuel pump relay circuit inside of the TIPM-7 with one external to the unit. The original part could allegedly cause the models to stall without warning. Even earlier, the company also recalled about 80,000 examples of the Jeep Wrangler and Dodge Nitro in 2007 to have the module reprogrammed.

Chrysler recalling 31k SUVs and vans

Chrysler is issuing recalls covering roughly 31,700 vehicles worldwide due to two separate problems. In both cases the company believes that most of the affected vehicles are either still on, or in transit to, dealer lots.
One recall covers roughly 10,700 Dodge Durango, Jeep Cherokee, Grand Cherokee and Grand Cherokee SRT models from the 2014 model year built between January 16 and April 17, 2014. The SUVs need a software update for the cruise control. It's possible that when the cruise is on and the driver presses on the throttle, the acceleration could last a second after the pedal is released or two seconds for the SRT. Afterward, they return to the speed originally set by the driver.
Chrysler says it isn't aware of any accidents, injuries or even reported incidents of this happening in the real world. Also, in all cases, if the driver presses on the brake, the cruise shuts off. The automaker believes that there are about 6,100 affected SUVs in the US, 950 in Canada, 425 in Mexico and 3,200 outside of North America. The software upgrade will be ready shortly, the company says.

Dodge Viper recall requires small-handed mechanics

It has been over a year since Chrysler first announced its recall of 3,660 2003-2004 Dodge Vipers because the airbag could suddenly deploy. The repairs are finally beginning, and it appears to be a nightmare for mechanics.
According to the automaker's filing with the National Highway Traffic Safety Administration, the airbag control module can fail, which causes the bag or the seatbelt pre-tensioner to deploy without warning. It took over a year to design the new parts, according to The New York Times. However, Chrysler finally has a new "jumper harness with an in-line diode filter circuit" ready to fix the problem.
The dilemma now moves to the mechanics who have to actually install the part. A 47-step guide from Chrysler explains that the procedure should take about two hours. It's not an easy job, though. Most of the dashboard has to be taken apart, and the instructions include this helpful bit of advice: "Installing the jumper harness and filter box into position is not an easy task. Patience, perseverance, and small hands are required." We wish the best of luck to them. The fix comes just in time for the Vipers to enjoy the summer sun.