2014 Se 30th Anniversary New 3.6l V6 24v Automatic Fwd on 2040-cars

Auto blog

Mopar unveils Dodge Challenger Drag Pak [w/video]

Dodge is going drag racing, and it's doing it with an all-new version of the Challenger for NHRA's Sportsman class. FCA's Mopar parts and performance arm announced the new Challenger Drag Pak Friday, showing off a version with a 354-cubic-inch (that's a 5.8-liter, by the way), supercharged V8 and a 426-ci (7.0-liter), naturally aspirated V8 – both Hemis, of course – that can get the big coupes through the quarter-mile in "the eight-second range." While the two engines deliver similar performance, at their base, they're quite a bit different. The supercharged model uses a cast-iron block, while the 426 has aluminum for both the block and head. That said, both models get customized engine calibrations, and are mated to unique, race-spec automatic transmissions. But drag racing is about far more than just outright power. Mopar significantly updated the four-link rear suspension, adding a four-inch rear axle from Strange Engineering, along with an aluminum, nine-inch third member, while the rear-axle housing has been strengthened in general. Both the rear shocks and front struts can be adjusted for rebound and compression, too. Lightweight 15-inch wheels, meanwhile, are shod in super-sticky Hoosier drag radials, with nine inches of tread in back and 4.5 inches in front. The new Challenger Drag Pak should run the quarter-mile in "the eight-second range." In the cabin, there's an NHRA-spec roll cage, a Racepak gauge cluster, and a handsome pair of Sparco racing seats. Outside, supercharged models get blue decals, while naturally aspirated varieties get black stickers, although there's more to the new Challenger dragster's exterior than just its decals. Mopar tweaked the big-scoop hood, promising it's easier to get up to check on the engine, and the designers also added trailer tie-down straps in both the front and rear. While the dragster was the big news today, Mopar officials also announced the two enhanced Scat Pack kits for both the Dodge Charger and Challenger R/T. The 5.7-liter Hemi models gain an extra 56 horsepower and 30 pound-feet of torque in the Scat Pack 2 thanks to a new cam, valve springs, pushrods, and gaskets. The Scat Pack 3, meanwhile, adds 75 hp and 44 lb-ft, on top of the gains from the lower packages. That should be perfect for drivers who wish to snort in the face of their SRT 392-driving friends. The third stage adds a ported cylinder heads, as well as high-flow manifolds and catalysts.

VLF Force 1 V10 is a rebodied Viper priced like a Lamborghini

It would appear that Henrik Fisker is done with hybrids. His latest project, called the Force 1, packs an oversized V10 engine with no electric assist in sight and all the environmental credentials of a herd of flatulent cattle. Alongside the Karma-based, Corvette-powered Destino, the Force 1 is the second product from VLF Automotive. Fisker has taken partnership in the new firm as chief designer alongside chairman Bob Lutz and CEO Gilbert Villarreal. The company isn't saying explicitly what the Force 1 is based on, but it doesn't take a CSI team to trace its roots back to the Dodge Viper. Never mind that it's being built in Auburn Hills – the same Detroit suburb where Chrysler is headquartered – or that it was jointly developed by Fisker and professional Viper racer and dealer Ben Keating. It also happens to be powered by an 8.4-liter V10, and there aren't many of those kicking around the industry. Instead of the Viper's 645 horsepower and 600 pound-feet of torque, the Force 1's ten-cylinder engine is optimized to deliver 745 hp and 638 lb-ft. That, according to VLF, is enough to send the coupe rocketing to 60 in 3.0 seconds flat, covering the quarter-mile in under 11 seconds on its way to a top speed of 218 miles per hour. The power is transmitted to the Pirelli PZero rubber through a six-speed manual, but VLF says it will fit it with an automatic at the customer's request. Around that massive engine and two-seat cockpit, Fisker designed a new shape that, for better or for worse, looks way more aggressive than the Viper's. The Force 1's proportions are tellingly super-snake, but the curves are replaced by some very angry-looking angles and vents. Its head- and taillights are ultra thin, and the deep-dish, split-four-spoke wheels seem to visually split the difference between the three-spoke wheels on the original Viper and the five-spoke alloys it wears today. If you doubted the Force 1's origins before, the interior ought to give it away, with its wide tunnel and familiar surfaces. Only VLF has refinished it in leather, suede, and Alcantara, all diamond stitched with contrasting thread to help position this as a more luxurious prospect than the Dodge. It even fit between the seatbacks place for two champagne bottles that we hope nobody would consider consuming before trying to handle that much power. Of course, none of this will come cheap.

Dodge Charger Pursuit takes Tesla interior approach

A police car's computer is just as integral to its duties as a set of lights and sirens. The popular approach for these systems is to grab something like a Panasonic Toughbook laptop, add a big, bulky tray to hold it, and use this inelegant setup for running plates and doing all the other things a cop needs to do while on the road. The downside, besides simple aesthetics, is that this arrangement robs the officer's shotgun-riding partner from legroom. Dodge, though, has come up with a far more elegant and functional solution. Taking a page out of Tesla and Volvo's book, Dodge has replaced the five-inch UConnect display and laptop mount in the Charger Pursuit police car with an enormous 12.1-inch, portrait-format touchscreen display. Called, UConnect 12.1, the new system doesn't do away with the old fashioned computer outright. Instead it moves the bulky unit to the trunk, where it can connect to the display via an ethernet cable. This is good for multiple reasons. First, there are no pricey installation or upfitting charges, like there are for most laptop carriages. Secondly, the plug-and-play nature of the new UConnect system won't require the department to buy new laptops. And third, there's no need to retrain officers, since the only thing that's really changing is the input. While the Charger Pursuit will continue to offer redundant audio and HVAC controls, the 12.1-inch display can, at the press of a "button" split to display Fiat Chrysler's familiar 8.4-inch display. Make one more tap on the screen, and the police-issue laptop can be managed through the full touchscreen. The touchscreen will also display a menu bar at the top of the page, which can easily be edited by officers. All it takes is a simple drag and drop from the application menu to the top of the display. According to Dodge, the touchscreen will even play nice when its operator is wearing gloves. "As America's high-performance police vehicle, Dodge Charger Pursuit is going big for 2016, offering a massive, Uconnect touchscreen system that streamlines a law enforcement officer's computer system with our easy-to-use Uconnect system – on an all-new laptop-sized 12.1-inch touchscreen display," said Tim Kuniskis, Dodge and SRT's president and CEO.