1972 Dodge Demon H-code on 2040-cars

Auto blog

Chrysler recalls 350k vehicles over ignition switches

Chrysler has announced a recall covering 349,442 vehicles due to ignition switches that can either become stuck or move without warning. All of the affected vehicles are from the 2008 model year, and were built before May 12, 2008.
The automaker has learned that ignition keys on some vehicles "may not fully return to the 'ON' position after rotation to the 'START' position during engine-startup," the company said in a statement. Additionally, "an ignition key may not fully return to the 'ON' position after rotation to the 'START' position and may inadvertently move through the 'ON' position to 'ACCESSORY' or 'OFF.'"
Chrysler says it is unaware of any related injuries, and notes that while reduced braking, engine or steering power is possible in such instances, the airbags are not affected. The later stands in contrast to General Motors' recent rash of high-profile recalls, and it's an important distinction that Chrysler (understandably) felt necessary to call out in bold print in its press release.

Chrysler recalling 278,222 trucks and SUVs over bad rear axles

Chrysler has issued a recall of 278,222 light trucks and sport utility vehicles here in the United States. The reason: bad rear axles. Specifically, according to the National Highway Traffic Safety Administration, the rear axle pinion nut may lack a necessary adhesive patch, which could cause the nut to loosen. If this happens, the axle can lock up, which could cause all sorts of havoc on the road.
This is an expansion of the rear axle recall announced in October of last year, where 44,300 Ram 1500 and Dodge Dakota models were being called in. At that time, 12 accidents had been reported due to the faulty axle pinion nut.
Affected vehicles include Ram 1500 trucks from the 2009 to 2012 model years, Dodge Dakota models from the 2009 to 2011 model years, and both the Chrysler Aspen and Dodge Durango SUV twins, both from the 2009 model year only.

NHTSA investigating power modules on Chrysler Group SUVs and minivans

The Center for Auto Safety is officially petitioning the National Highway Traffic Safety Administration to begin scrutinizing alleged problems with the totally integrated power module (TIPM) on about 24 Chrysler Group SUVs and minivans. The advocacy group claims that the part's failure can cause affected vehicles to stall or not start at all. NHTSA is still looking into the accusations and deciding whether a full investigation is actually warranted.
The CAS petition claims at least 70 TIPM failures, but according to NHTSA, six of the complaints are for models that don't have the modules. In 34 of the reported cases, the vehicles refused to start, and in 17 of them the engine stalled. There were also two allegations of smoke and one of a fire. However, none of these affected airbag deployment or resulted in a crash.
This petition isn't the first TIPM-related problem for Chrysler Group. A recent report in the New York Times alleged that it found 240 complaints potentially related to the issue on NHTSA's website alone. In September, the automaker also recalled 230,760 examples worldwide (188,723 in the US) of the 2011 Jeep Grand Cherokee and Dodge Durango replace the fuel pump relay circuit inside of the TIPM-7 with one external to the unit. The original part could allegedly cause the models to stall without warning. Even earlier, the company also recalled about 80,000 examples of the Jeep Wrangler and Dodge Nitro in 2007 to have the module reprogrammed.