2005 Dodge Dakota St on 2040-cars

Auto blog

Preserved truck found at the bottom of frozen lake

A fisherman in central Minnesota pulled more than bluegill and bass out of his local fishing hole earlier this month. While ice fishing on Mayhew Lake, a local man was startled when, using an underwater camera to scout for fish, he discovered a vehicle sitting on the lakebed, the SCTimes reported. He immediately called the Benton County Sheriff's office, which sent deputies to examine the vehicle. Once they arrived, the deputies used their own camera to have a look and discovered a late-90s to early-00s model Dodge Ram pickup in roughly 12 feet of water. The Sheriff's department dive team was then dispatched to search the truck and the area surrounding it for bodies or valuables. The truck was lifted from the lakebed through a huge hole in the ice. The Sheriff's office ran the plates and discovered that it was reported stolen in March of 2000 from a nearby address. Investigators believe that given the truck's location, almost 100 yards from the lake's public access ramp and 25 yards from the north shore, that it was driven on to the lake while it was frozen, then allowed to sink to the bottom once the ice melted. Thanks to the lake's frigid waters, the truck was surprisingly well preserved. Aside from a missing grille, a coating of mud inside, and a patina of rust on the sheet metal, there was little damage to the truck despite its long rest in the lake. With an engine full of lake water and the damage done by roughly sixteen freeze-thaw cycles, the truck will never run again, but its condition is a good testament to the build quality of those old Rams. It certainly held up better than that '57 Plymouth Belvedere they buried in the time capsule under the Tulsa city courthouse. News Source: SCTimesImage Credit: Benton County Sheriff's Office Government/Legal Weird Car News Dodge Truck water lake

2013-14 Dodge Viper recalled over faulty door handles

The 2013-14 Dodge Viper is getting a voluntary recall affecting 1,762 cars worldwide to replace their door-handle assemblies. Of the affected vehicles, FCA US reports there are 1,451 in the US, 160 in Canada, 17 in Mexico and 59 of them outside of NAFTA. After receiving three reports of doors either not closing or opening while driving a low speeds, FCA US engineers found a new sealant from a supplier didn't provide sufficient moisture protection to the electronic switches for the door latches. If the parts get wet, this can potentially cause a short circuit. The automaker is quite clear that are no reports of accidents of injuries from this problem. As always, the recall repairs will be done at no cost to owners, and FCA US will be getting in touch with customers soon about the problem. Related Video: Statement: Door-handle Assemblies April 9, 2015 , Auburn Hills, Mich. - FCA US LLC is voluntarily recalling an estimated 1,762 cars globally to replace their door-handle assemblies. FCA US launched an investigation after the Company received three warranty claims linked to doors that failed to close or opened inadvertently while vehicles were moving at low speed. The Company is unaware of any related injuries or accidents. Engineers determined a sealant, newly adopted by a supplier, provided inconsistent moisture protection to the electronic switches that control the door latches. Switches exposed to moisture may short-circuit. Affected are approximately 1,451 model-year 2013-14 Dodge Viper SRT cars in the U.S.; 160 in Canada; 17 in Mexico and 59 outside the NAFTA region. Affected customers will be notified and advised when they may schedule service, which will be performed at no cost. Customers with questions may call the FCA US Customer Information Center at 1-800-853-1403.

The last time Dodge recycled the Demon name, it was for a Miata fighter

We and the rest of the automotive world are eagerly awaiting the reveal of the Dodge Challenger Demon. And why wouldn't we be? It's going to be a Hellcat, but with less weight, bigger fenders, more performance, and more Vin Diesel. This isn't the first time we've been excited about a Demon from Dodge, though. Ten years ago, Dodge had another demonic car, but it was very different from the new one. The Demon of 2007 was a lithe little roadster that looked primed and ready to take on the Miata, as well as the now-departed Solstice and Sky twins. The Demon was just under an inch shorter than the MX-5 and the Solstice, and it packed a 172 horsepower 2.4-liter four-cylinder that fell right between the Miata's 170 and the Solstice's 177 outputs. Dodge's estimated the curb weight, which for a concept is largely theoretical, also slotted between the two cars at 2600 pounds. That was about 150 more than the Mazda, and about 200 less than the Pontiac. The pitch perfect specifications were presented in a crisp two-seat roadster wrapper. In many ways, it looked like a baby Viper, with a menacing crosshair grille, slanted headlights, and fat rear fenders. The Demon's line's were brutally simple and geometric, too. They didn't seem far removed from the first-generation Audi TT. The interior was also plain and simple. The key highlights were a horizontal aluminum accent that ran the width of the dash, echoed by an aluminum-covered center console. The instrument cluster was uncluttered, with just four gauges, and the only controls were some climate knobs, a double-DIN head unit, and a six-speed manual. It turns out that the 2007 Demon didn't drive very well, though. You see, we actually drove this concept back in the day, and like many concepts, it still had a long way to go to be production ready. The gearbox would grind, the ride quality was terrible. However, the interior was roomy, and the engine sounded suitably grumbly, if a bit coarse. At the time, we said Dodge should absolutely build the little roadster. In retrospect, the company probably made the right decision not to invest in the Demon. The small rear drive sports car segment was, and still is, an extremely niche market. It would have been a big investment for little return, something FCA today is trying to avoid. This is all before taking into account the fact that the recession was just around the corner. In the end, we can't be too sad though.