Find or Sell Used Cars, Trucks, and SUVs in USA

2001 Dodge Dakota Quad on 2040-cars

US $1,500.00
Year:2001 Mileage:198641 Color: Blue
Location:

Prosser, Washington, United States

Prosser, Washington, United States
Advertising:
Transmission:Automatic
Fuel Type:Gasoline
For Sale By:Private Seller
Vehicle Title:Clean
Engine:3.9L Gas V6
Seller Notes: “Just don’t have a use for it, would make a good project/starter/parts truck. Happy to send any additional info or photos.” Read Less
Year: 2001
VIN (Vehicle Identification Number): 1B7GL2AX21S158620
Mileage: 198641
Trim: QUAD
Number of Cylinders: 6
Make: Dodge
Drive Type: RWD
Model: Dakota
Exterior Color: Blue
Condition: UsedA vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections. See all condition definitions

Auto Services in Washington

Wild West Cars & Trucks ★★★★★

New Car Dealers, Used Car Dealers
Address: 8830 Lake City Way NE, Duvall
Phone: (206) 523-1400

Walker`s Renton Mazda ★★★★★

New Car Dealers, Used Car Dealers
Address: 200 S Grady Way, Covington
Phone: (425) 277-1370

Volkswagen Repair ★★★★★

Auto Repair & Service
Address: 19611 International Blvd, Seatac
Phone: (206) 789-5516

Valley Automotive Specialties ★★★★★

Auto Repair & Service, Auto Oil & Lube
Address: 810 E Highway 902, Fairchild-Afb
Phone: (509) 299-5446

Tveten`s Auto Clinic ★★★★★

Auto Repair & Service
Address: 5425 Lakewood Towne Center Blvd SW, Steilacoom
Phone: (253) 588-5201

Stillbuilt Automotive ★★★★★

Auto Repair & Service
Address: 3115 T Ave, Blakely-Island
Phone: (360) 299-8252

Auto blog

This 93-car Iowa auction is like a Big 3 classic muscle museum

Tue, Aug 27 2019

Bill "Coyote" Johnson has been buying cars since high school and has amassed a collection totaling 113 vehicles, according to NBC 6 News. But time has changed his motivations and priorities, and he's decided to auction 93 of those cars, many of which are classic muscle from Ford, Chevrolet, Dodge, Plymouth and Pontiac. The megasale will take place Sept. 14, 2019, in Red Oak, Iowa, at the Montgomery County Fairgrounds. A 1969 Plymouth Road Runner infected Coyote with a love for Detroit muscle when he was just a teenager, and his desire quickly turned into an obsession. He's spent the past 40 years finding, buying and working on a variety of makes and models. Unlike some collectors, Coyote didn't discriminate against certain brands and has rides from each of the Big 3 automakers. Included in the auction are Camaros, Satellites, Super Bees, Chargers, Challengers, Barracudas, Coronets, GTOs, Mustangs, Cutlasses and others. Possibly the most intriguing aspect of the auction is that all of these cars will be sold as-is with no reserve. Many of them will need work, depending on quality standards, but this seems like a golden opportunity to find a classic car without leaving a bank account in shambles.  The auctions are open for bidding online now, and the full auction will take place on September 14. Check out the full listings and bid at VanDerBrink Auctions.

Dodge Demon makes so much torque, it needs stronger driveline parts

Thu, Mar 2 2017

Torque is a lovely thing, a sweet and wonderful force that twists and pulls and can help propel a two-ton metal box forward at comical speeds. Torque is also fickle and will bend and break those same metal parts without a second thought, which is why the new Dodge Demon is compensating for its increased torque with some new re-engineered and reinforced parts. And there's software intended to combat wheel hop, which one of the most dramatic ways torque can break stuff. Week 8's video, "Race-hardened Parts," gives a hint towards what all these new parts can do. While we still don't know how much torque the Demon will throw out, we do know it's enough to warrant an upgraded prop shaft, half shafts, and a differential housing. The Challenger Hellcat, which is the basis for the Demon, makes 650 pound-feet of torque already. The new parts will go a long way toward making sure the work from the Demon's engine is properly translated into motion by those Nitto drag radials. The new prop shaft uses high-strength steel, heat-treated stub-shafts, and increases the tube thickness by 20 percent for a 15 percent increase in torque capacity. Additionally, Dodge says the upgraded differential housing allows for a 30 percent increase in torque capacity by using heat-treated A383 aluminum alloy and a higher strength shot-peened gear set. The 41-spline half shafts that deliver 20 percent increased torque capacity through the use of high-strength low alloy steel and 8-ball joints. In addition to the hardware, the Launch Assist software has been tuned to help alleviate wheel hop. Dodge says the Demon is the first factory production car that uses wheel speed sensors to detect hop and momentarily cut torque to compensate. This means a driver can keep their foot planted on the floor while the computer sorts out the traction. Previously, the best solution was to back off the throttle to manually cut the load. Finally, the Dodge Demon will offer a four-point harness mounting bar as an optional accessory. The part will be supplied by Speedlogix and fits in place of the deleted rear seat. Customers can install the bar without having to hack apart their cars to find a proper mounting point. Look for more teasers and info on ifyouknowyouknow.com in the lead-up to the Demon's debut at the 2017 New York Auto Show. Related Video: Image Credit: FCA Dodge Performance dodge demon dodge hellcat

Dodge Charger Pursuit takes Tesla interior approach

Fri, Sep 11 2015

A police car's computer is just as integral to its duties as a set of lights and sirens. The popular approach for these systems is to grab something like a Panasonic Toughbook laptop, add a big, bulky tray to hold it, and use this inelegant setup for running plates and doing all the other things a cop needs to do while on the road. The downside, besides simple aesthetics, is that this arrangement robs the officer's shotgun-riding partner from legroom. Dodge, though, has come up with a far more elegant and functional solution. Taking a page out of Tesla and Volvo's book, Dodge has replaced the five-inch UConnect display and laptop mount in the Charger Pursuit police car with an enormous 12.1-inch, portrait-format touchscreen display. Called, UConnect 12.1, the new system doesn't do away with the old fashioned computer outright. Instead it moves the bulky unit to the trunk, where it can connect to the display via an ethernet cable. This is good for multiple reasons. First, there are no pricey installation or upfitting charges, like there are for most laptop carriages. Secondly, the plug-and-play nature of the new UConnect system won't require the department to buy new laptops. And third, there's no need to retrain officers, since the only thing that's really changing is the input. While the Charger Pursuit will continue to offer redundant audio and HVAC controls, the 12.1-inch display can, at the press of a "button" split to display Fiat Chrysler's familiar 8.4-inch display. Make one more tap on the screen, and the police-issue laptop can be managed through the full touchscreen. The touchscreen will also display a menu bar at the top of the page, which can easily be edited by officers. All it takes is a simple drag and drop from the application menu to the top of the display. According to Dodge, the touchscreen will even play nice when its operator is wearing gloves. "As America's high-performance police vehicle, Dodge Charger Pursuit is going big for 2016, offering a massive, Uconnect touchscreen system that streamlines a law enforcement officer's computer system with our easy-to-use Uconnect system – on an all-new laptop-sized 12.1-inch touchscreen display," said Tim Kuniskis, Dodge and SRT's president and CEO.