Dodge Coronet 440 on 2040-cars

Auto blog

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

Chrysler recalling 780k minivans over fire risk

Chrysler is recalling 780,000 of its Town & Country and Dodge Grand Caravan minivans from the 2010 to 2014 model years due to the possibility of circuits overheating, which can lead to a fire. Of the 780,000 total vans being recalled, Chrysler estimates that 644,850 are in the US, 106,980 are in Canada, 8,009 are in Mexico, and 20,638 are in other markets. All of the affected vehicles were built between August 25, 2010 and October 31, 2013.
Chrysler's engineers discovered that beverage spills or exposure to moisture (from rain, snow, car washes, and the like) were linked to circuits shorting in the window switch assembly. Short circuits can overheat, and thus, cause a fire.
Chrysler will contact owners and let them know when they may schedule service, at which point, the window switches will be replaced. In the interim, the automaker says that owners may visit their dealers after May 14 to have the switches disconnected.

Chrysler to accelerate production of 2013 Ram and V6 engines

Chrysler is adding a third shift at its Warren Truck plant to meet demand for the new 2013 Ram pickup. And with tight supplies of its Pentastar V6, the company is also boosting output at its Mack Engine plant.
The expansions will add 1,250 jobs and are part of a $238 million investment by Chrysler in the Detroit area. Warren's third shift will begin work sometime in the spring, a Chrysler rep told Automotive News. Mack's increased Pentastar production a could include both 3.6 and 3.2-liter engines.
The company says it also plans to invest $40 million in its Trenton Engine plant to allow for production of a 3.2-liter V6 as well as the Tigershark inline-four for the upcoming Jeep Liberty replacement.