1966 Dodge Coronet 500 Convertible 440 on 2040-cars

Auto blog

Chrysler recalls 1.2 million Ram pickup trucks

Chrysler has announced that it will issue three separate recalls that will cover as many as 1.2 million Ram pickup trucks for "steering-system tie rods that may have been misaligned during assembly or steering-system service." The vast majority of these trucks were sold in the United States, though some trucks in Mexico, Canada or overseas will be called in, as well.
The largest of the three recalls covers an estimated 842,400 model-year 2003-2008 Ram 2500 and 3500 trucks. Two smaller campaigns will bring 294,000 model-year 2008-2012 Ram 2500 and 3500 pickups, chassis cabs and 2008 Ram 1500 4x4 Mega Cabs; plus 43,500 model-year 2008-2012 Ram 4500 and 5500 4x4 chassis cabs into the dealer to be checked and repaired if necessary.
This is a very large recall, and Chrysler says it is "casting the net wider than necessary to identify those vehicles that require repair." The automaker estimates that "as many as 726,000 may not need repair."

NHTSA investigating Chrysler for airbags, ignition switches

Chrysler is being targeted by the National Highway Traffic Safety Administration in a pair of actions that focus on over 1.2 million Jeeps, minivans and crossovers.
The first is a "preliminary investigation" that focuses on an airbag issue afflicting the Jeep Commander built in model years 2006 and 2007 and Grand Cherokee from 2005 to 2006. In total, 700,000 vehicles could potentially be affected. It's not entirely clear what the airbag issue is, with The Detroit Free Press simply stating that the restraint systems in the affected Jeeps may be "faulty."
The other investigation is what's called a "recall query" and it covers a problem that General Motors should be familiar with. In this case, there could be a problem with the ignition switches of 525,000 vehicles, ranging from 2008 to 2010 Chrysler Town & Country and Dodge Grand Caravan minivans, to the 2008 to 2010 Dodge Journey crossover. Again, it's not entirely clear what sort of behavior prompted the 32 complaints that NHTSA has received on these vehicles.

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.