Dodge Charger Se Sedan 4-door on 2040-cars

Auto blog

2015 Dodge Challenger SRT Hellcat [w/videos]

Darrell Waltrip once said, "If the lion didn't bite the tamer every once in a while, it wouldn't be exciting." The sentiment behind that aphorism is causing my adrenal gland to wake up as Dodge and SRT drivers and engineers - somber-faced to a man - give me the track talk that will precede my driving the 2015 Dodge Challenger SRT on the circuit at Portland International Raceway. PIR might not be Daytona, and the 707-horsepower Challenger Hellcat might seem tame to a legend like ol' Jaws, but there's a not-small part of me that's thinking about how hard Dodge's fire-breathing kitty might bite.
Just a few hours previous, I'd gotten behind the wheel of the Hellcat for the first time, letting its hyperbole-spitting, supercharged V8 Hemi pull me yieldingly through Portland's morning commuter traffic. Lulled into a cocky certainty by the Challenger's good manners at low speed, I drove the throttle just a hair too deep, too fast when I ran on to the highway ramp. For just an instant the rear tires were utterly drenched in torque, and the back end of the big Dodge loosened up like a drift car on a wet track. Throttle steer lives at the fleeting whim of your right foot in this car.
It was no big thing to lay off the gas and pull the Hellcat back in line as I entered the highway, but the incident did get me to thinking: What will this car do to me on a road course?

Dodge Viper to out-Hell the Hellcat with supercharged V10?

The Viper wouldn't be the Viper if it wasn't the most powerful model under the Chrysler umbrella. But with the arrival of the Hellcat engine in the Dodge Charger and Challenger, the Viper has fallen behind in the bragging rights department: where the new supercharged V8 produces 707 horsepower and 650 pound-feet of torque, the naturally aspirated V10 offers "only" 640 hp and 600 lb-ft - gargantuan output figures by almost any other standard, but crucially behind on the SRT power scale. Conner Avenue is going to have to do something about that.
Although the Hellcat's engine reportedly won't fit under the Viper's hood, SRT is now rumored to have another trick up its sleeve: supercharge the existing V10. According to the Pentastar performance enthusiasts at allpar.com, Chrysler has already taken delivery of the first such prototype engines so that it can begin the process of fitting it into an upgraded Viper.
The spooled ten-pot is tipped to produce around 800 hp and 650 lb-ft of torque. More than that and the Viper's drivetrain, chassis and bodywork would have to be substantially reworked. Though beefier transmissions are available, fitting them would reportedly set off a domino-game of changes required to handle the added torque. Which may be something Chrysler would be prepared to do for the next-generation model, but in the meantime, 800 hp could prove enough to put the Viper back atop the Mopar performance ladder where it belongs, and give it an edge against the new Corvette Z06 to rekindle sales.

FCA recalling 63k Jeeps, Vipers and Ram ProMaster City vans

Fiat Chrysler Automobiles has announced a pair of recalls cover nearly 63,000 vehicles. The bigger of the two actions covers manual-transmission-equipped vehicles from 2006, including the Jeep Liberty and Wrangler, as well as the Dodge Viper. FCA engineers uncovered that the clutch ignition interlock switches use a kind of wire that was part of a previous recall campaign. Because of this, the company said that affected vehicles may not start, although in rare cases, "if recommended starting procedures are not followed," the affected vehicles may lurch forward after turning the key. Those recommended starting procedures "include activating the parking brake, placing the shift lever in neutral and pressing the clutch pedal before turning the vehicle's ignition key." Recall number two affects the company's 2015 Ram ProMaster City cargo and passenger vans. Owners will need to report to dealers to have a piece of tape removed from the side-curtain airbags. The tape is added during assembly and in some cases, may not have been removed. That could prevent the airbags from deploying in the event of a crash. Just under 59,000 vehicles are included in the first recall, including 43,874 in the United States, 11,309 outside of North America, 2,944 in Canada and 706 in Mexico. The ProMaster City recall includes just over 3,900 vehicles. FCA claims it's unaware of any injuries, fatalities or accidents related to either recall and will perform repairs free of charge. Scroll down for the official press release on both campaigns. Related Video: Statement: Clutch Ignition Interlock Switch April 23, 2015 , Auburn Hills, Mich. - FCA US LLC is launching a voluntary recall of an estimated 43,874 older-model U.S.-market cars and SUVs equipped with manual transmissions. The Company will replace their clutch ignition interlock switches at no charge to customers. The action follows an investigation by FCA US engineers that discovered these vehicles are equipped with switches that contain a certain type of wire implicated in a previous campaign. The wire, which was temporarily substituted by a supplier for the specified material, may break. As a result, the vehicles may not start, and in rare cases – if recommended starting procedures are not followed – a vehicle may exhibit unintended movement when its ignition key is turned. FCA US is unaware of aware of any related injuries or accidents involving this population of vehicles.