2010 Dodge Charger Sxt on 2040-cars

Auto blog

Indications of 825 hp and emissions issues for Hellcat called 'speculation' by Chrysler

The 2015 Dodge Challenger SRT Hellcat is probably one of the hottest cars of the moment mostly because of its insane, 707-horsepower supercharged V8. However, there are conflicting reports coming out that the powerplant might be having problems with its emissions compliance and may be capable of even more power.
Jalopnik says that an unnamed source within Fiat Chrysler Automobiles told it that the Hellcat was having problems meeting emissions standards at its 707-horsepower tune. The person claimed that the automaker has been testing the V8 with different types of sensors, possibly to make it a bit cleaner in the future. Autoblog spoke to SRT spokesperson Dan Reid, and he said about the claimed poor emissions, "It's totally speculation."
The source also claimed that the Hellcat had been dynoed at a monumental 825 horsepower, internally. Based on the other rumor, though, it's hard to imagine the engine being emissions compliant like that. Autoblog also asked Reid about this speculation about more power and was told, "They are totally speculating about that."

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

Chop the top of your new Dodge Viper for $35,000

We have good news, and we have bad news. First, the good: It's now possible to get a brand-new Dodge Viper roadster, which is nice, considering we're in the dead of summer and many of us like wind-in-the-hair motoring. Now, the bad: This is not a factory option from the automaker, instead coming courtesy of an aftermarket company called Prefix Performance, and that means it's going to cost you some serious coin.
Called Medusa, this drop-top Viper was created without the knowledge or consent of Dodge, but that's probably fine because Prefix works with the automaker already for the final preparation of the American supercar, including paint. According to the company, the current, fifth-gen Viper was built with a convertible version in mind, so no chassis strengthening is required. From the looks of the somewhat grainy photos available, the conversion appears of very high quality.
Want one? Well, that means you're going to need to procure a Viper - Prefix has 10 units ready for transformation as it stands - and that's going to cost at the very least $102,485. Then, you'll need to write a check for an additional $35,000 for Prefix to surgically remove the car's roof. Thing is, for that kind of cash, a prospective owner could buy, among other very nice options, a Viper hardtop and a loaded Miata, or a Corvette Stingray convertible and several pockets full of change. Or, perhaps a new Viper hardtop and a used, first-gen Viper convertible?