2010 Dodge Charger Srt8 on 2040-cars
Pasadena, Texas, United States
For Sale By:Dealer
Engine:6.1L 6059CC 370Cu. In. V8 GAS OHV Naturally Aspirated
Body Type:Sedan
Transmission:Automatic
Fuel Type:GAS
Cab Type (For Trucks Only): Other
Make: Dodge
Warranty: Unspecified
Model: Charger
Trim: SRT8 Sedan 4-Door
Disability Equipped: No
Drive Type: RWD
Doors: 4
Mileage: 11,039
Drive Train: Rear Wheel Drive
Sub Model: SRT8
Number of Doors: 4
Exterior Color: Other
Interior Color: Other
Number of Cylinders: 8
Dodge Charger for Sale
1969 dodge charger - original 4spd - runs!(US $9,000.00)
Original 1966 dodge charger
1968 dodge charger general lee 318 non matchin numbers(US $14,500.00)
1972 dodge charger base hardtop 2-door 5.2l
2010 dodge charger sxt sedan 4-door 3.5l
2009 dodge charger se, cd, aux, automatic trans, cruise, power trunk(US $13,777.00)
Auto Services in Texas
Zeke`s Inspections Plus ★★★★★
Value Import ★★★★★
USA Car Care ★★★★★
USA Auto ★★★★★
Uresti Jesse Camper Sales ★★★★★
Universal Village Auto Inc ★★★★★
Auto blog
Chrysler says its 8-speed transmissions will save 700 million gallons
Thu, Jun 19 2014Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.
Dodge idles Viper production again at Conner Avenue
Mon, 07 Jul 2014You've got to hand it to Dodge for having the gumption to put the original Viper into production in the first place. It was, after all, much more of an emotional decision than a practical one, and a move which saw the first production V10 engine placed in a road car - long before the advent of the Lamborghini Gallardo, Audi R8, Porsche Carrera GT or Lexus LFA, not to mention the other Ford, BMW and Volkswagen Group models that used such engines.
It's now been 22 years since the first Viper entered production and the Viper still rolls on several generations later, but we're sad to say that courageous decision has not always been met with overwhelming sales success. In fact parent Chrysler was forced to idle the Conner Avenue plant where the Viper is made back in April due to slow sales. And while production resumed again as planned on June 23, it apparently didn't do the trick.
As a result, Chrysler corporate communications chief Shawn Morgan revealed to Autoblog that the assembly line has been shut down again for another two weeks. The line was up and running for nearly two full work weeks from June 23 until the holiday weekend that started on Thursday, July 3. But instead of coming back online today as planned, it's been idled again for the weeks of July 7 and 14. That means it will be July 21, at the earliest, before the serpentine supercars start slithering down the assembly line at Conner Avenue again. Once it does, however, production is set to resume at the same pace it was before the shutdown.
China's Geely says it has no plan to buy Fiat Chrysler — as FCA stock leaps
Wed, Aug 16 2017HONG KONG — Chinese carmaker Geely Automobile denied media speculation on Wednesday that it planned to make a takeover bid for Fiat Chryslerk Automobiles (FCA), the world's seventh-largest automaker. Geely was one of several Chinese carmakers cited in by Automotive News, which said representatives of "a well-known Chinese automaker" had made an offer this month for FCA, which has a market value of almost $20 billion. "We don't have such a plan at the moment," Geely executive director Gui Shengyue told reporters at an earnings briefing, when asked if Geely was interested in Fiat. He said a foreign acquisition would be complicated, but he did not elaborate. "But for other (Chinese) brands, it could be a fast track for their development," Gui added. However, a source close to the matter said FCA and Geely Automobile's parent firm, Zhejiang Geely Holding Group, had held initial talks late last year, without disclosing their nature. The source confirmed Geely was no longer interested in FCA, noting that the parent company had only three months ago announced its first push into Southeast Asia with the purchase of 49.9 percent of struggling Malaysian carmaker Proton, a deal that also included a stake in Lotus. Geel's denial failed to dent FCA's stock. The price of its Milan-based shares has jumped more than 10 percent to a 19-year high since Automotive News first reported on Monday, citing unnamed sources, that FCA had rejected the Chinese offer as too low. FCA stock on the New York Stock Exchange rose sharply on Monday from $11.60 to $12.38 and on Wednesday was trading at $12.84. FCA declined to comment on Wednesday. FCA Chief Executive Sergio Marchionne has repeatedly called for mergers as a way of sharing the costs of making cleaner, more advanced cars, but he has repeatedly failed to find a partner and retreated from his search for in April, saying FCA would stick to its business plan. He has also spoken of spinning the successful Jeep and Ram divisions off from FCA. Europe's largest carmaker, Volkswagen, and General Motors have both said they are not interested in talks with FCA. On Wednesday, Geely Automobile reported a doubling of first-half profit, above expectations, as cars designed with Sweden's Volvo won over domestic consumers. Volvo is a unit of the Zhejiang Geely group, and has recently announced it will share its technology with Geely.