2009 Dodge Charger 4dr Sdn R/t Rwd on 2040-cars

Auto blog

Chrysler investing $20M in Toledo plant to support 9-speed auto production

In 2011, Chrysler announced a $72-million investment in its Toledo Machining Plant to modernize production of the eight- and nine-speed torque-converters for automatic transmissions made there. That upgrade work won't be finished until Q3 of this year, but Chrysler has already announced a further $19.6-million investment to increase production capacity for the nine-speeders.
The extra units will be necessary because the nine-speed transmission they'll be mated to is going into three popular models: it will debut on the 2014 Jeep Cherokee, then go into the Chrysler 200 and Dodge Dart. The company predicted that this year alone it would sell 200,000 units equipped with the nine-speed tranny, and it is spending some $374 million in addition to the investment in Toledo to upgrade production capacity for it.
The work attached to this new investment won't begin until Q3 of 2014, and it will be finished by the end of that year. There's a press release below with all the details.

NHTSA is investigating FCA shifters for roll-away accidents again, this time the rotary units

It seems FCA's shifter troubles aren't over yet. Now, just a few months after issuing a recall to resolve user-related issues with its monostable shifters, the company is again under investigation by NHTSA. The issue is related to the potential for cars to roll away when the rotary-style shifter is not properly placed in park. Two FCA models are the subject of this investigation: the 2013–2016 Ram 1500 and the 2014–2016 Dodge Durango. NHTSA estimates about 1,000,000 vehicles would be affected if a recall is issued. The investigation was started following 43 complaints of vehicles rolling away while supposedly being in "park." Among the complaints were reports of 25 crashes and 9 injuries. NHTSA does point out that in every incident, the parking brake was not engaged. A representative from FCA also gave us an official statement regarding the investigation: "FCA US is cooperating fully with NHTSA's investigation, the scope of which is limited. Other vehicles equipped with rotary shifters are not included. In accordance with prudent practice, the Company joins NHTSA in urging all drivers to use their vehicles' parking brakes." View 35 Photos As mentioned above, other Chrysler products with rotary shifters, such as the Pacifica minivan and 200 sedan, are not involved in this investigation. One of the key differences, as the representative told us, is that these vehicles have electronic parking brakes that automatically engage if the driver does not select park and then opens the door with the seatbelt unbuckled. The Ram 1500 and Durango feature mechanical, manually operated parking brakes and therefore cannot activate the brake automatically. Because this is currently an investigation, an exact cause for the incidents has yet to be determined, and none of the vehicles have been recalled. It's possible there could be a mechanical defect. However, the issue could be a confusing interface causing user error, as was the case with FCA's monostable shifters, where drivers think they've put the car in park but actually haven't. Something that indicates it could be a case of confused users is that NHTSA also opened an investigation into 2012–2014 Jaguar XF and Land Rover Range Rover Evoques for similar issues. Both vehicles use a rotary shifter and have had roll-away complaints levied as well. Even if it is a case of user error, FCA and Jaguar Land Rover may still have to recall their vehicles.

2015 Dodge Viper GTC available in 25 million no-cost combos with 1 Of 1 bespoke program

What's the one thing no car can have too much of? Here's a hint – it's not power. It's not efficiency, either, or technology, or even safety. It's exclusivity. It's one reason Rolls-Royce has become a legend building absolutely bespoke motor vehicles, and it's the reason Dodge, of all companies, is offering a new GTC trim level for its Viper supercar. Now, you might be asking what's so special and exclusive about a trim level? Well, in the Viper GTC's case, it gives owners access to a catalog of 8,000 shades of paint for the exterior, 24,000 "hand-painted" custom stripe patterns, 10 different wheel options, 16 interior trims and no fewer than six aerodynamic packages. That results in 25 million different configurations for the 645-horsepower snake. Most shockingly, the customization choices come at no additional cost on the GTC model. And it's only the start. Ordering a GTC will enroll customers in a unique VIP program called Viper Concierge, which according to Dodge, "offers an exclusive point of contact throughout the custom Viper build process." In other words, buyers will be given the means to stay right on top of their car's production, through the 140-to-160-hour painting process, which itself will be fully documented with pictures and through a mobile-friendly website, to the actual construction of their GTC. The Concierge process will start with the ordering stage, which will include Dodge sending customers a paint chip showing the owner's custom choosing, which they can confirm or refuse. Shortly thereafter, Dodge will send buyers a 1:18-scale "speed-form" replica in their chosen custom colors, once again to confirm or deny the build. Once the buyer's color and option selection is locked-in, that car becomes a one-of-one Viper for that year – no other buyer will be permitted to build a Viper to the same specifications. The concierge service also grants access to the Viper Ambassador Owner's Portal, where orderers can track their car's build process, receive weekly updates and share their excitement with (jealous) friends and family. And once the car is complete, it will be fitted with a custom dash plaque identifying its bespoke provenance – the owner can choose to have their name put on the badge, the car's nickname, or whatever they wish (Dodge will also ship each Viper with a second blank plate to include if the original owner sells the car).