2006 Dodge Charger Sxt Sedan 4-door 3.5l on 2040-cars

Auto blog

Dodge Charger Hellcat makes 1,032 hp with Hennessey help

Sometimes you just want four doors. Earlier this week we brought you Hennessey's riff on the Dodge Challenger Hellcat. Now comes the Charger. Much like its two-door sibling, the Charger gets boosted to as much as 1,032 hp and 987 lb-ft of torque (at the crank) thanks to the addition of a twin-turbocharging setup that works with the factory supercharger. The turbo headers and downpipes are stainless steel, and there is a high-flow air-to-water intercooler and dual-turbo waste gates. Hennessey also beefs up the fuel injectors, fuel pump, and the rest of the fuel system. The engine management system and chassis are recalibrated to accommodate all of this. You also get numbered plaques signed by John Hennessey, the boss of the Texas tuning outfit, and the technician who does your build. Hennessey's additions result in zero-to-60 mph sprints in 2.7 seconds, and the big sedan can run the quarter mile in 9.9 seconds at 142 mph. Like the Challenger, the Charger has the same disclaimer: the lofty horsepower figure comes from an engine dyno, and it will be a 15-to 20-percent lower at the rear wheels. Related Video: Image Credit: Hennessey Performance Dodge Performance Sedan Hennessey dodge charger hellcat

Chrysler killing off the 200 Convertible, Dodge Avenger

When Chrysler rolled out the first-generation 200 to replace the Sebring range in 2010, it included replacements for both the sedan and the convertible. The Sebring Coupe, however, was left out of the mix. And now that the second-generation Chrysler 200 is descending upon us, Auburn Hills is paring things down even further. But this time, it's the convertible that reportedly isn't making the cut. Shame, too, since the rendering above shows what could have been quite an attractive droptop.
As our compatriots at Edmunds point out, sales of the convertible model accounted for less than five percent of overall Chrysler 200 sales, and at those numbers, the considerable cost of engineering a new drop-top couldn't be justified. With the Toyota Camry Solara and Volkswagen Eos also gone from the market (well, the VW isn't gone quite yet), the discontinuation of the Chrysler 200 Convertible leaves the affordable convertible segment largely to the sportier likes of the Ford Mustang and Chevy Camaro and smaller European offerings like the Mini Cooper and VW Beetle.
The Chrysler 200 Convertible isn't the only derivative being left behind with the new model: so too is the Dodge Avenger. That will leave a glaring hole in the Dodge lineup, with nothing to bridge the gap between the compact Dart and the larger Charger. Whether the Dodge brand has any plans to replace the Avenger with another model, not to be based on the 200, remains to be seen.

FCA adds 88k Dodge Challengers to Takata inflator recall

The Takata airbag inflator recall from FCA US is growing 88,346 vehicles larger in the US after the company's discovery of the faulty parts in the 2008-2010 Dodge Challenger. The affected examples have production dates between September 19, 2007, and October 29, 2010, and the coupes need the replacement components on the driver's side. According to chronology posted by the National Highway Traffic Safety Administration (as a PDF), the automaker was auditing the models covered under the campaign in July and "identified a population of vehicles that was inadvertently excluded." Initially, FCA believed these cars were using an unrecalled Takata inflator. The audit revealed that the affected cars indeed used a recalled version. As with the rest of the faulty parts, exposure to moisture can cause them to ignite too quickly during an airbag deployment and spray shrapnel at occupants. The problem has been linked to at least eight deaths worldwide and a vehicle fire in Japan. The Challenger wasn't previously part of FCA's 3.3-million unit national campaign or the subsequent expansion. According to FCA US the parts to complete the repairs in these Challengers aren't currently available. However, owners will be notified of the issue by mail starting August 14. They will receive a second notice when the parts become available. Related Video: RECALL Subject : Driver Side Frontal Air Bag Inflator May Rupture Report Receipt Date: JUL 10, 2015 NHTSA Campaign Number: 15V444000 Component(s): AIR BAGS Potential Number of Units Affected: 88,346 All Products Associated with this Recall Vehicle Make Model Model Year(s) DODGE CHALLENGER 2008-2010 Details Manufacturer: Chrysler (FCA US LLC) SUMMARY: Chrysler (FCA US LLC) is recalling certain model year 2008-2010 Dodge Challenger vehicles manufactured September 19, 2007, to October 29, 2010. The affected vehicles are equipped with a dual-stage driver frontal air bag that may be susceptible to moisture intrusion which, over time, could cause the inflator to rupture. CONSEQUENCE: In the event of a crash necessitating deployment of the driver's frontal air bag, the inflator could rupture with metal fragments striking the driver or other occupants resulting in serious injury or death. REMEDY: Chrysler will notify owners, and dealers will replace the driver's frontal air bag inflator, free of charge. Parts to remedy the vehicles are not currently available. Interim notices will be mailed to owners beginning August 14, 2015.