2010 Dodge Challenger Srt8 6 Speed Manual 2-door Coupe on 2040-cars

Auto blog

Chrysler recalling 278,222 trucks and SUVs over bad rear axles

Chrysler has issued a recall of 278,222 light trucks and sport utility vehicles here in the United States. The reason: bad rear axles. Specifically, according to the National Highway Traffic Safety Administration, the rear axle pinion nut may lack a necessary adhesive patch, which could cause the nut to loosen. If this happens, the axle can lock up, which could cause all sorts of havoc on the road.
This is an expansion of the rear axle recall announced in October of last year, where 44,300 Ram 1500 and Dodge Dakota models were being called in. At that time, 12 accidents had been reported due to the faulty axle pinion nut.
Affected vehicles include Ram 1500 trucks from the 2009 to 2012 model years, Dodge Dakota models from the 2009 to 2011 model years, and both the Chrysler Aspen and Dodge Durango SUV twins, both from the 2009 model year only.

2003-04 Dodge Viper recalled for sudden airbag deployment

As if driving the old Dodge Viper (not the fancy new SRT model) isn't intimidating enough, imagine trying to wrangle that V10 beast and then suddenly having the airbags deploy. Yikes. That's apparently what could happen to some 3,660 Viper models from the 2003 and 2004 model years, and as such, Chrysler has issued a recall.
According to the National Highway Traffic Safety Administration, part of the car's airbag control module may fail, causing the bags or seatbelt pre-tensioners to deploy without warning while the vehicle is in operation. That's a dangerous scenario in any car, let alone one offering insane horsepower a near-total paucity of safety nannies should things get squirrely.
Owners will be notified this month about the recall, though a remedy is not expected to be available until later this year. Scroll down for the full NHTSA statement.

Dodge Charger Hellcat makes 1,032 hp with Hennessey help

Sometimes you just want four doors. Earlier this week we brought you Hennessey's riff on the Dodge Challenger Hellcat. Now comes the Charger. Much like its two-door sibling, the Charger gets boosted to as much as 1,032 hp and 987 lb-ft of torque (at the crank) thanks to the addition of a twin-turbocharging setup that works with the factory supercharger. The turbo headers and downpipes are stainless steel, and there is a high-flow air-to-water intercooler and dual-turbo waste gates. Hennessey also beefs up the fuel injectors, fuel pump, and the rest of the fuel system. The engine management system and chassis are recalibrated to accommodate all of this. You also get numbered plaques signed by John Hennessey, the boss of the Texas tuning outfit, and the technician who does your build. Hennessey's additions result in zero-to-60 mph sprints in 2.7 seconds, and the big sedan can run the quarter mile in 9.9 seconds at 142 mph. Like the Challenger, the Charger has the same disclaimer: the lofty horsepower figure comes from an engine dyno, and it will be a 15-to 20-percent lower at the rear wheels. Related Video: Image Credit: Hennessey Performance Dodge Performance Sedan Hennessey dodge charger hellcat