Red Viper Gts, Laguna Interior,white Stripes,venom-hyper Wheels,high Perf Audio on 2040-cars

Auto blog

Chrysler recalling 67k trucks with manual transmissions

Earlier this month, Chrysler announced the recall of some 280,000 pickup trucks over concerns that their axles could seize up. Now the automaker has announced an entirely separate recall of another 66,819 trucks over the springs that could break in the clutch ignition interlock switch. The recall affects Dodge Ram 1500, 2500 and 3500 pickups, as well as the Dodge Dakota and Mitsubishi Raider. The issue is relevant only to those trucks fitted with manual transmissions, from the 2006 and 2007 model years and manufactured between July 1, 2005, and July 31, 2006. Since a broken spring could, according to statements issued by the National Highway Traffic Safety Administration and FCA US LLC (previously known as the Chrysler Group) prevent the vehicle from starting, or cause it to move unintentionally once the ignition kicks over, the automaker will begin notifying owners of the affected vehicles just before Valentine's Day to bring their trucks into their local dealers to have the clutch ignition interlock switch replaced. FCA emphasizes, however, that the unintended movement would only occur "in rare cases" and only "if recommended starting procedures are not followed." Only one such case is known to have occurred, but it did regrettably result in a fatality. Statement: Clutch Ignition Interlock Switch December 29, 2014 , Auburn Hills, Mich. - FCA US LLC is launching a voluntary global recall of an estimated 66,819 older-model pickup trucks equipped with manual transmissions. The Company will replace their clutch ignition interlock switches at no charge to customers. An investigation by FCA US engineers discovered switches in certain model-year 2006 and 2007 pickups may be equipped with spring wire that differs from wire used in previous switches. The alternate wire may break and, as a result, the vehicles may not start. In rare cases, a vehicle may – if recommended starting procedures are not followed – exhibit unintended movement when its ignition key is turned. The Company is aware of one fatality related to this campaign. It stemmed from the single known accident involving this population of vehicles. The recall covers certain Dodge Dakota, Dodge Ram 1500, 2500, 3500 and Mitsubishi Raider pickups. Switches with the alternate wire were not used in any vehicles produced before July of 2005, or after June of 2006. The Dakota and Raider are no longer in production.

Mopar unveils Dodge Challenger Drag Pak [w/video]

Dodge is going drag racing, and it's doing it with an all-new version of the Challenger for NHRA's Sportsman class. FCA's Mopar parts and performance arm announced the new Challenger Drag Pak Friday, showing off a version with a 354-cubic-inch (that's a 5.8-liter, by the way), supercharged V8 and a 426-ci (7.0-liter), naturally aspirated V8 – both Hemis, of course – that can get the big coupes through the quarter-mile in "the eight-second range." While the two engines deliver similar performance, at their base, they're quite a bit different. The supercharged model uses a cast-iron block, while the 426 has aluminum for both the block and head. That said, both models get customized engine calibrations, and are mated to unique, race-spec automatic transmissions. But drag racing is about far more than just outright power. Mopar significantly updated the four-link rear suspension, adding a four-inch rear axle from Strange Engineering, along with an aluminum, nine-inch third member, while the rear-axle housing has been strengthened in general. Both the rear shocks and front struts can be adjusted for rebound and compression, too. Lightweight 15-inch wheels, meanwhile, are shod in super-sticky Hoosier drag radials, with nine inches of tread in back and 4.5 inches in front. The new Challenger Drag Pak should run the quarter-mile in "the eight-second range." In the cabin, there's an NHRA-spec roll cage, a Racepak gauge cluster, and a handsome pair of Sparco racing seats. Outside, supercharged models get blue decals, while naturally aspirated varieties get black stickers, although there's more to the new Challenger dragster's exterior than just its decals. Mopar tweaked the big-scoop hood, promising it's easier to get up to check on the engine, and the designers also added trailer tie-down straps in both the front and rear. While the dragster was the big news today, Mopar officials also announced the two enhanced Scat Pack kits for both the Dodge Charger and Challenger R/T. The 5.7-liter Hemi models gain an extra 56 horsepower and 30 pound-feet of torque in the Scat Pack 2 thanks to a new cam, valve springs, pushrods, and gaskets. The Scat Pack 3, meanwhile, adds 75 hp and 44 lb-ft, on top of the gains from the lower packages. That should be perfect for drivers who wish to snort in the face of their SRT 392-driving friends. The third stage adds a ported cylinder heads, as well as high-flow manifolds and catalysts.

Are supercars becoming less special?

There's little doubt that we are currently enjoying the golden age of automotive performance. Dozens of different models on sale today make over 500 horsepower, and seven boast output in excess of 700 hp. Not long ago, that kind of capability was exclusive to supercars – vehicles whose rarity, performance focus, and requisite expense made them aspirational objects of desire to us mortals. But more than that, supercars have historically offered a unique driving experience, one which was bespoke to a particular model and could not be replicated elsewhere. But in recent years, even the low-volume players have been forced to find the efficiencies and economies of scale that formerly hadn't been a concern for them, and in turn the concept of the supercar as a unique entity unto itself is fading fast. The blame doesn't fall on one particular manufacturer nor a specific production technique. Instead, it's a confluence of different factors that are chipping away at the distinction of these vehicles. It's not all bad news – Lamborghini's platform sharing with Audi for the Gallardo and the R8 yielded a raging bull that was more reliable and easier to live with on a day-to-day basis, and as a result it went on to become the best-selling Lambo in the company's history. But it also came at the cost of some of the Italian's exclusivity when eerily familiar sights and sounds suddenly became available wearing an Audi badge. Even low-volume players have been forced to find economies of scale. Much of this comes out of necessity, of course. Aston Martin's recent deal with Mercedes-AMG points toward German hardware going under the hood and into the cabin of the upcoming DB11, and it's safe to assume that this was not a decision made lightly by the Brits, as the brand has built a reputation for the bespoke craftsmanship of its vehicles. There's little doubt that the DB11 will be a fine automobile, but the move does jeopardize some of the characteristic "specialness" that Astons are known for. Yet the world is certainly better off with new Aston Martins spliced with DNA from Mercedes-AMG rather than no new Astons at all, and the costs of developing cutting-edge drivetrains and user interfaces is a burden that's becoming increasingly difficult for smaller manufacturers to bear. Even Ferrari is poised to make some dramatic changes in the way it designs cars.