Extremely Rare 1 Of 88 Made $90k Invested! Corsa Exhaust, K&n, Upgrades $ Mint! on 2040-cars

Auto blog

Chrysler says its 8-speed transmissions will save 700 million gallons

Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

Chrysler Recalling 700k Vehicles For Ignition Switch Woes

General Motors isn't the only automaker with ignition switch problems. Chrysler is fighting it too and is now announcing a recall of 695,957 examples worldwide of the Chrysler Town & Country and Dodge Grand Caravan minivans from the 2008-2010 model years, plus the 2009-2010 Dodge Journey. According to a statement from Chrysler, the models have a bad wireless ignition node detent ring in the ignition switch, making it possible for drivers to appear to have the key in the "Run" position but for the spring not to fully engage. It can then slip back to the "Accessory" position and shut the car off. If this happens, the vehicle loses power steering, brake boost and the airbags. There is some disparity about the number of vehicles affected under this recall. In its statement, Chrysler claims that it covers 525,206 vehicles in the US, 102,892 in Canada, 25,591 in Mexico and 42,268 elsewhere. However, the recall announcement posted by The National Highway Traffic Safety Administration lists an estimated 438,109 vehicles in the US. Chrysler spokesperson Nick Cappa told Autoblog via email that the reasoning for the different figures "will become clear at a later date." To fix the problem, Chrysler will install a new detent ring in the vehicles. It will begin contacting owners soon, and obviously the repair will be free of charge. This isn't the first time this problem has cropped up in these models. Chrysler issued a recall for 248,437 vehicles in 2011 for certain 2010 model year examples. A few weeks ago, NHTSA also began investigating the 2008-2010 model years of the affected models for ignition switch problems. At this time, it's not clear whether that evaluation and this campaign are linked. Chrysler told Autoblog that it has no reports of injuries related to the problem. Scroll down to read the company's statement and the NHTSA recall report. Statement: Expansion of Wireless Ignition Node (WIN) safety recall July 1, 2014 , Auburn Hills, Mich. - Out of an abundance of caution, Chrysler Group is expanding a previous safety recall to install a more robust WIN module detent ring. A previous recall in 2010 included 196,000 Chrysler Town & Country, Dodge Grand Caravan and Dodge Journey vehicles built August 2, 2009 through June 17, 2010. The expansion includes an additional 695,957 vehicles manufactured January 29, 2007 through August 1, 2009.