1998 - Dodge Viper on 2040-cars

Auto blog

Chrysler readying Hellcat V8 with Viper-like power

A monstrous supercharged V8 engine could be in store for Chrysler and SRT products, if recent rumors are to be believed. Allpar is reporting that the forced-induction V8 - Chrysler's first, if this goes down - could make its debut this summer.
The story goes that the Hellcat would be based on a 6.2-liter Hemi engine, rather than on the existing 5.7- or 6.4-liter versions of the company's vaunted mill. In any case, the general consensus is that the motor will have gobs of power. Modest estimates call for between 500 to 570 horsepower, with some outliers predicting a figure as high as 600 hp. That figure would put the output would place the Hellcat awfully close to that of the 640-hp V10 in the SRT Viper, too. Allpar contends that a slightly lower powered version would allow Chrysler to keep costs below that of the more powerful Ford Shelby GT500, which might be a sweet spot.
The Hellcat could debut in a number of SRT products. SRT versions of the Charger, Challenger and 300 are all up for grabs, as is the rumored SRT Barracuda.

Dodge recalls 27k Darts for bracket that can disrupt transmission module

Dodge is recalling 27,520 examples of the 2013-2015 Dart with dual-clutch gearboxes. The mounting bracket for the transmission control module can affect the part's operation and cause the compacts to suddenly shift into neutral. According to the automaker, 23,688 of them are in the US, 3,376 in Canada, 5 in Mexico, and 451 elsewhere. The National Highway Traffic Safety Administration reports these examples carry build dates between February 24, 2012, and June 16, 2015. There are also no reports of accidents or injuries. Because of the way the bracket is mounted, the part can put too much force on the control module's circuit board and cause it to shift out of gear. The engine and airbags remain operable if this happens. To fix things, dealers will install a redesigned mount and replacement module. Related Video: Statement: Mounting Bracket September 14, 2015 , Auburn Hills, Mich. - FCA US LLC is recalling an estimated 23,688 cars in the U.S. to replace certain control modules and mounting brackets that may contribute to a loss of motive power. The Company is unaware of any related injuries or accidents. An FCA US investigation prompted by a small number of warranty claims discovered a control-module mounting bracket may apply too much force and disrupt the function of a circuit board within the module. This condition, unique to certain cars equipped with dual dry-clutch transmissions (DDCT), may cause the transmission to shift into neutral. However, the engine remains on and the vehicle's air-bags, as well as other safety features, are unaffected. The condition may also be preceded by the illumination of a dashboard warning light. Customers who observe this are urged to contact their dealers. The campaign is limited to certain 2013-2015 Dodge Darts equipped with DDCTs. Additional vehicles will be recalled in Canada (3,376), Mexico (five) and outside the NAFTA region (451). Affected customers will be advised when they may schedule service, which will be performed free of charge. Service will entail installation of a redesigned mounting bracket and replacement of the control module. Customers with additional questions may call the FCA US Customer Information Center at 1-800-853-1403.

Watch Atieva's electric van outrun a BMW i8 and Dodge Viper

A little while back, automotive startup Atieva drag raced its electric van, called Edna, against a Tesla Model S and a Ferrari California in order to compare its performance against known and revered mechanical athletes. Again, the Silicon Valley-based company is putting its prototype up against electrified and conventionally powered performance vehicles on the drag strip. Last time around, Edna, the Mercedes-Benz Vito van equipped with a 900-horsepower, all-wheel-drive powertrain, bested both of its foes. In that showcase, Edna was hitting 60 mph in a little over three seconds. Comparatively, BMW lists the i8's 0-60 time at 4.2 seconds, though Road & Track clocked it at 3.8 seconds, with a quarter-mile time of 12.3 seconds. The Viper does 0-60 in 3.4 seconds. Before you even watch the video above, you can imagine how it will end, as the retuned Atieva Edna rips 0-60 mph in 2.94 seconds. Atieva clocked the quarter mile at 11.3 seconds at 117 mph. It's worth noting that driver skill can have a lot to do with a car's straight-line performance. We've witnessed Viper's elapsing the quarter mile in well under 12 seconds, which means it should be quicker in this test than the i8, if not the Edna. Still, the performance showcased in the video is exceptional. To improve Edna's stats, Atieva says it has used testing data to fine tune its AC induction motors at higher speeds once it got low-speed performance locked in. After testing in the hot California sun, including the race you see above, Atieva drove Edna 90 miles home with range to spare. As for production plans, Atieva will put this powertrain into a sedan slated for sale in 2018. In the meantime, the company will keep testing and tuning its working prototype, and has even invited the public to put their cars up against Edna in future sessions. Related Video: Related Gallery 2015 BMW i8 in Petoskey, MI News Source: Atieva, YouTube: Atieva via Electrek Green Motorsports BMW Dodge Automakers Electric Future Vehicles Videos drag race atieva