5.9l Cummins Diesel Mega Cab Bed Liner Nerf Bars Hard Tonneau Trailer Brake Dvd on 2040-cars

Auto blog

2013-14 Dodge Viper recalled over faulty door handles

The 2013-14 Dodge Viper is getting a voluntary recall affecting 1,762 cars worldwide to replace their door-handle assemblies. Of the affected vehicles, FCA US reports there are 1,451 in the US, 160 in Canada, 17 in Mexico and 59 of them outside of NAFTA. After receiving three reports of doors either not closing or opening while driving a low speeds, FCA US engineers found a new sealant from a supplier didn't provide sufficient moisture protection to the electronic switches for the door latches. If the parts get wet, this can potentially cause a short circuit. The automaker is quite clear that are no reports of accidents of injuries from this problem. As always, the recall repairs will be done at no cost to owners, and FCA US will be getting in touch with customers soon about the problem. Related Video: Statement: Door-handle Assemblies April 9, 2015 , Auburn Hills, Mich. - FCA US LLC is voluntarily recalling an estimated 1,762 cars globally to replace their door-handle assemblies. FCA US launched an investigation after the Company received three warranty claims linked to doors that failed to close or opened inadvertently while vehicles were moving at low speed. The Company is unaware of any related injuries or accidents. Engineers determined a sealant, newly adopted by a supplier, provided inconsistent moisture protection to the electronic switches that control the door latches. Switches exposed to moisture may short-circuit. Affected are approximately 1,451 model-year 2013-14 Dodge Viper SRT cars in the U.S.; 160 in Canada; 17 in Mexico and 59 outside the NAFTA region. Affected customers will be notified and advised when they may schedule service, which will be performed at no cost. Customers with questions may call the FCA US Customer Information Center at 1-800-853-1403.

Chrysler readying Hellcat V8 with Viper-like power

A monstrous supercharged V8 engine could be in store for Chrysler and SRT products, if recent rumors are to be believed. Allpar is reporting that the forced-induction V8 - Chrysler's first, if this goes down - could make its debut this summer.
The story goes that the Hellcat would be based on a 6.2-liter Hemi engine, rather than on the existing 5.7- or 6.4-liter versions of the company's vaunted mill. In any case, the general consensus is that the motor will have gobs of power. Modest estimates call for between 500 to 570 horsepower, with some outliers predicting a figure as high as 600 hp. That figure would put the output would place the Hellcat awfully close to that of the 640-hp V10 in the SRT Viper, too. Allpar contends that a slightly lower powered version would allow Chrysler to keep costs below that of the more powerful Ford Shelby GT500, which might be a sweet spot.
The Hellcat could debut in a number of SRT products. SRT versions of the Charger, Challenger and 300 are all up for grabs, as is the rumored SRT Barracuda.

Chrysler recalling 644k more Dodge Durango and Jeep Grand Cherokee SUVs over brakes

Early last month, we reported on Chrysler issuing a preemptive, proactive recall for about 25,000 units of the Jeep Grand Cherokee and Dodge Durango. The issue revolved around a brake system that wasn't causing any actual problems, but delivered an unsatisfactory brake feel, so Auburn Hills called in a good 25,000 of SUVs around the world, including 18,700 in the United States.
Now Chrysler, having apparently determined that the brake problem on its sport utes is actually much bigger than it initially realized, has drastically broadened the scope of the recall. As a result, the National Highway Traffic Safety Administration has issued a recall for precisely 655,354 examples of the Grand Cherokee and Durango, covering the 2011 through 2014 model years. In addition, Chrysler is recalling 42,380 units in Canada, 21,376 in Mexico and 159,685 overseas.
The problem which Chrysler found revolves around the brake booster, whose center shell has been found to be subject to corrosion, allowing water to get into the brake system. That water in turn could freeze, preventing the brakes from working as well as expected.