2010 Dodge Ram 2500 6.7 Cummins 4x4 4wd Six Speed 6 Manual Diesel St Long Bed on 2040-cars

Auto blog

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

Chrysler recalling nearly half a million Durangos and Grand Cherokees

Rule number one of public relations – save the bad news for Friday. Fiat Chrysler has adhered to that, announcing today that it'd be voluntarily recalling 467,480 SUVs. This latest recall could actually be thought of as a continuation of a September 2014 recall, relating to the fuel-cell relay. In that case, some 188,723 Dodge Durango and Jeep Grand Cherokee CUVs from model year 2011 were recalled. And this time, it's the Durango and GC in trouble again. FCA is adding crossovers from model years 2012 and 2013 to the fuel-pump recall, although only diesel-powered Jeeps with the 3.0-liter V6 that were sold outside of North America are affected this time around. As with the previous recall, deformities in the fuel-pump relay, which could affect its functioning. In most cases, FCA reports that the affected vehicles simply won't start, although they also could be prone to stalling. A new relay circuit will be installed that promises increase durability. Of the 467,480 vehicles being recalled, 338,216 were sold in the US market, 18,991 went to Canada and 10,829 were shipped south of the border, to Mexico. Outside of the NAFTA region, FCA is recalling 99,444 vehicles. No injuries or accidents have been associated with this recall. Statement: Fuel-Pump Relay February 27, 2015 , Auburn Hills, Mich. - FCA US LLC is voluntarily recalling an estimated 467,480 SUVs worldwide to install new a relay circuit that improves fuel-pump relay durability. FCA US engineers have determined a condition identified in a previous investigation may extend to additional vehicles. The previous investigation, which led to a recall, traced a pattern of repairs to fuel-pump relays that are susceptible to deformation. This may affect fuel-pump function, preventing a vehicle from starting, or leading to engine stall. Of the two scenarios, the no-start condition is the more common. FCA US is unaware of any related injuries or accidents. The fuel-pump relay is located inside the Totally Integrated Power Module (TIPM), which also helps manage other vehicle functions. None of these other functions, including air-bag deployment, is affected by the fuel-pump relay. The new campaign affects an estimated 338,216 vehicles in the U.S.; 18,991 in Canada; 10,829 in Mexico and 99,444 outside the NAFTA region. Covered are model-year 2012 and 2013 Dodge Durango full-size SUVs and non-NAFTA 2011 Jeep Grand Cherokee mid-size SUVs equipped with 3.0-liter diesel engines.

FCA plants skipping summer shutdown to keep up with demand

Hopefully, some FCA US factory employees don't have big plans for the usual summer shutdown, because the automaker is keeping several plants running this year. Demand is so high that the company wants to keep models rolling off the assembly lines. Four FCA US assembly plants, all the engine factories, and some locations that build transmissions are staying open throughout the summer, according to the Detroit Free Press. Usually, these sites would see a two-week shutdown for the company to retool and perform repairs. This year, factories are staying open for FCA to support its strong sales. The lines that remaining humming through the summer show an inclination toward the automaker's popular SUV's and crossovers. They include the Jefferson North Assembly Plant in Michigan that builds the Jeep Grand Cherokee and Dodge Durango; Saltillo Van Assembly in Mexico that constructs the Ram ProMaster; Toledo Assembly Complex in Ohio that produces the Cherokee and Wrangler; and Toluca Assembly in Mexico that makes the Dodge Journey and Fiat 500. Related Video: News Source: The Detroit Free PressImage Credit: Bill Pugliano / Getty Images Plants/Manufacturing Dodge Fiat Jeep RAM FCA dodge journey fca us ram promaster Jefferson North Assembly Plant