Quad Cab 4x4 5.7l Hemi All Power Spacer Lift W/17in Prem Alloys/off-road Tires on 2040-cars

Auto blog

Dodge Dart Mopar '13 special edition recalled over airbag woes

Dodge is only building 500 examples of the black-and-blue Mopar '13 Dart, but the majority of them are now being recalled. Part of the Mopar upgrade included replacing the stock seat skins in the Dart with black and blue Katzkin leather, but the seat-mounted side airbags were reinstalled improperly during the upfitting process, which could affect the performance of the front seat side airbags.
According to the official National Highway Traffic Safety Administration bulletin, a total of 374 Mopar '13 cars are being recalled due to side airbags that might not deploy in a side-impact collision. There have been no reports of the airbags not going off, but Chrysler will still need to reinstall the bags to ensure proper deployment. The recall notice is posted below, which gives information for Mopar '13 owners to contact Chrysler and NHTSA.

Dodge Challenger SRT Hellcat's 707 storming horses can be yours for $60k

We love a good deal on high performance. It's what traditionally makes muscle cars so appealing - you get lots of speed, for not a lot of money. For 2015, Dodge has taken this to its logical extreme, offering its new 707-horsepower, supercharged, V8-powered Dodge Challenger SRT Hellcat for just $59,900. For those wondering, that works out to just about $85 per horsepower, which when compared with a typical budget performance car, like the $24,995, 210-hp Volkswagen GTI ($119 per hp), demonstrates the Hellcat's astonishing value.
The information was revealed by a photo (click on the inset image to expand) taken at this week's Portland launch event (our man Seyth Miersma is just now on the ground and will have a full report on the madness that is the Hellcat soon) for the entire 2015 Challenger range, and reveals the Hellcat's price alongside its high-powered competitors from Ford and Chevrolet.
The discontinued 662-hp Mustang GT500 started at $56,000, while the 580-hp Camaro ZL1 starts off at $58K. Indeed, the only muscle car that outprices the Hellcat is the track-focused Camaro Z/28, a car that we're guessing could still wallop the Hellcat on the right piece of track, despite being down over 200 hp.

Chrysler says its 8-speed transmissions will save 700 million gallons

Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.