2003 Dodge Ram 1500! Slt! Short Bed! Reg Cab! 20 Inch Chromes! No Reserve! on 2040-cars

Auto blog

Big rig gets blown over on Wyoming freeway, flattens police cruiser

A big rig navigating a stretch of windy Wyoming highway last week was blown over by high winds and landed on a Wyoming Highway Patrol cruiser. According to CBS News, three Wyoming Highway Patrol troopers responded to an accident along Interstate 80 near Elk Mountain on February 7. While the troopers were out of their cars assisting the crash victims, a white Volvo semi-truck lumbered up I-80 toward them. Wind gusts in that part of Wyoming were clocked in at up to 90 miles per hour on Tuesday, and one of them caught the semi as it neared the parked cruisers. Video from one of the cruiser's onboard cameras showed the big rig drift to the right as a big gust hit the trailer. Slowly, the whole rig tipped over and flattened one of the parked cruisers. The truck then slid a few feet on its side and came to a stop just aft of the cruiser. None of the troopers were injured in the incident, and two people in the truck came out of it unhurt as well. Patrol Lieutenant David Wagener told KGWN that that stretch of I-80 was closed on Tuesday to lightweight, high-profile vehicles. The truck driver was cited for the incident. High winds are no joke, and vehicles getting blown around or even clean off the road is a pretty common phenomenon. Way back in 2011, a truck got blown over in Utah. Then there was a train that got blown off a bridge in Louisiana in 2015. Related Video: News Source: CBS News, KGWN Auto News Dodge Volvo Driving Safety Truck Commercial Vehicles Police/Emergency Sedan semi truck rollover wyoming

FCA updates 700k-vehicle recall to replace ignition switches

FCA US is revising a previously announced recall of 702,578 minivans and SUVs; now specifying that owners replace their ignition switches, rather than just a component. The campaign affects the 2008-2010 Chrysler Town & Country, 2008-2010 Dodge Grand Caravan and 2009-2010 Dodge Journey. The National Highway Traffic Safety Administration initially opened an investigation last summer following complaints about the ignition switches in these models. FCA US (then Chrysler Group) responded with a recall of 695,957 examples of these vehicles because the key could appear to be in the "Run" position but not be fully engaged. If it slipped out, and there was an accident, then the airbags might not deploy. The company had initially planned to install a new detent ring to fix the problem. According to the timeline in a NHTSA document (available here as a PDF), the government agency and FCA US continued their research into the problem. The automaker found that the time needed to create a new ring design and updated software would be longer than replacing the whole ignition switch. The company worked with the supplier Marquardt to negotiate an accelerated schedule to manufacture the extra replacement parts. According to NHTSA, the investigation has now been closed because of FCA's recall. Company spokesperson Eric Mayne confirms to Autoblog via email, "No additional vehicles are affected and all affected customers have already been made aware their vehicles are subject to recall." FCA US sent out an initial notification advising owners of the problem in September 2014. The company will now send out a second letter in April and will replace the parts in two phases. Repairs for affected models from the 2008 and 2009 model years will begin in April, and 2010 examples will start being fixed in August. RECALL Subject : Ignition Switch may Turn Off , 1 INVESTIGATION(S) Report Receipt Date: JUN 26, 2014 NHTSA Campaign Number: 14V373000 Component(s): AIR BAGS , ELECTRICAL SYSTEM Potential Number of Units Affected: 702,578 All Products Associated with this Recall Vehicle Make Model Model Year(s) CHRYSLER TOWN AND COUNTRY 2008-2010 DODGE GRAND CARAVAN 2008-2010 DODGE JOURNEY 2009-2010 Details Manufacturer: Chrysler Group LLC SUMMARY: This defect can affect the safe operation of the airbag system. Until this recall is performed, customers should remove all items from their key rings, leaving only the ignition key.

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.