1956 Dodge Pickup Service on 2040-cars

Auto blog

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

Dodge Scat Packages add Mopar performance upgrades in three stages

Dodge has revealed what it calls Scat Package Stage Kits that enhance the performance of the Charger and the Challenger equipped with the 5.7-liter V8, and the Dart equipped with the turbocharged 2.4-liter inline four-cylinder engine. The Scat Packs use Mopar performance parts that also can be bought separately. Most of the upgrades increase engine output, but Dodge somehow manages to not specifically mention the power gains associated with each Scat Pack.
The three Scat Packs offered for the V8-powered cars focus on higher power ratings, and each stage comes complete with a unique engine-management calibration to optimize output. Stage one comes with a cold-air intake and a cat-back exhaust; stage two adds a performance camshaft; and stage three really gives you the goods, adding ported polished cylinder heads and performance headers.
For the Dart, the Scat Packs focus on engine, transmission, chassis and brake upgrades. Stage one will net you a cold-air intake, a short-throw shifter and slotted rotors with performance brake pads; stage two adds a cat-back exhaust system and an engine-management calibration to increase output by taking advantage of premium-octane gasoline; and stage three adds 13-inch vented brake discs up front clamped by four-piston calipers, suspension with adjustable springs and struts and performance front and rear antiroll bars.

Chrysler readying Hellcat V8 with Viper-like power

A monstrous supercharged V8 engine could be in store for Chrysler and SRT products, if recent rumors are to be believed. Allpar is reporting that the forced-induction V8 - Chrysler's first, if this goes down - could make its debut this summer.
The story goes that the Hellcat would be based on a 6.2-liter Hemi engine, rather than on the existing 5.7- or 6.4-liter versions of the company's vaunted mill. In any case, the general consensus is that the motor will have gobs of power. Modest estimates call for between 500 to 570 horsepower, with some outliers predicting a figure as high as 600 hp. That figure would put the output would place the Hellcat awfully close to that of the 640-hp V10 in the SRT Viper, too. Allpar contends that a slightly lower powered version would allow Chrysler to keep costs below that of the more powerful Ford Shelby GT500, which might be a sweet spot.
The Hellcat could debut in a number of SRT products. SRT versions of the Charger, Challenger and 300 are all up for grabs, as is the rumored SRT Barracuda.