Silver Turbo 4g63 Swapped Swap Mighty Max Ram 50 on 2040-cars

Auto blog

FCA CEO Mike Manley will run Americas for Stellantis after PSA merger

DETROIT — Fiat Chrysler CEO Mike Manley will run operations in the Americas when his company merges with FranceÂ’s PSA Peugeot early next year. FCA Chairman John Elkann announced ManleyÂ’s new post on Friday in a letter to employees. ManleyÂ’s role in the merged company had been a mystery. PSA CEO Carlos Tavares will run the overall company, to be named Stellantis. Shareholders of both companies will vote on the merger Jan. 4 to seal the deal creating the worldÂ’s fourth-largest automaker. The merger is expected to be completed by the end of March. PSA will get six seats on the new companyÂ’s 11-member board, which will be chaired by Elkann. The Americas, especially the U.S., are key to the new companyÂ’s success. Fiat ChryslerÂ’s Jeep and Ram brands are highly profitable, and Tavares has long wanted to sell PSA vehicles in the U.S. Manley has been the Italian-American automakerÂ’s CEO for 2 1/2 years, taking over when Sergio Marchionne died in 2018. Stellantis will have the capacity to produce 8.7 million cars a year, just behind Volkswagen, the Renault-Nissan alliance and Toyota. Related Video: Hirings/Firings/Layoffs Chrysler Dodge Fiat Jeep RAM Citroen Peugeot Mike Manley Stellantis

NHTSA investigating power modules on Chrysler Group SUVs and minivans

The Center for Auto Safety is officially petitioning the National Highway Traffic Safety Administration to begin scrutinizing alleged problems with the totally integrated power module (TIPM) on about 24 Chrysler Group SUVs and minivans. The advocacy group claims that the part's failure can cause affected vehicles to stall or not start at all. NHTSA is still looking into the accusations and deciding whether a full investigation is actually warranted.
The CAS petition claims at least 70 TIPM failures, but according to NHTSA, six of the complaints are for models that don't have the modules. In 34 of the reported cases, the vehicles refused to start, and in 17 of them the engine stalled. There were also two allegations of smoke and one of a fire. However, none of these affected airbag deployment or resulted in a crash.
This petition isn't the first TIPM-related problem for Chrysler Group. A recent report in the New York Times alleged that it found 240 complaints potentially related to the issue on NHTSA's website alone. In September, the automaker also recalled 230,760 examples worldwide (188,723 in the US) of the 2011 Jeep Grand Cherokee and Dodge Durango replace the fuel pump relay circuit inside of the TIPM-7 with one external to the unit. The original part could allegedly cause the models to stall without warning. Even earlier, the company also recalled about 80,000 examples of the Jeep Wrangler and Dodge Nitro in 2007 to have the module reprogrammed.

What's the deal with Chrysler demanding colleges crush their Vipers? [w/video]

Students and teachers at a Washington community college are up in arms following an order from Chrysler that it must destroy the pre-production Dodge Viper that was donated to the school's automotive technology program ten years ago.
The Viper in question is said to be the fourth off the production line, based on its VIN, and has had its emissions controls disabled, allowing its ten-cylinder engine to produce 600 horsepower, according to a report from Yahoo! Autos. As one of the first Vipers ever produced, the school's AT instructors claim it could be worth $250,000 in a museum, while a local news report purports that Jay Leno once tried to purchase the car, but the sale was prevented by Chrysler.
As pointed out by our friends at Autobytel, though, there are a lot of things in this story that don't quite add up. Immediately noticeable from the news report embedded below - which shows the car at South Puget Sound Community College - is that the car in question is not a 1992 model. When the Viper went on sale in 1992, it was only available as an RT/10 with a (flimsy) soft top, like the red car shown above. But the car featured in the report from KING5 News (inset image) is clearly a hardtop Viper GTS, which didn't enter production until 1996. And even if, as reported by a local newspaper, the hardtop featured is a prototype, it doesn't explain the lack of another iconic feature of the first Vipers - their distinctive side pipes. This kind of pokes holes in the school's argument that this is the fourth Viper to ever roll down the line. At best, this appears to be a pre-production Viper GTS.