Find or Sell Used Cars, Trucks, and SUVs in USA

1941 Dodge Truck Restored Running Driving Chassis on 2040-cars

Year:1941 Mileage:0
Location:

East Troy, Wisconsin, United States

East Troy, Wisconsin, United States
Vehicle Title:Clear
Fuel Type:Gasoline
Engine:6 cyl
For Sale By:Private Seller
Year: 1941
Drive Type: Rear
Make: Dodge
Mileage: 0
Model: Other Pickups
Trim: truck
Condition: Used: A vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections. ... 

 Restored 1941 dodge half ton truck running and driving chassis

This chassis has been rebuilt from the ground up with no expense spared.

The restoration started by stripping down every nut and bolt then stripping the chassis of all surface rust and paint.    The chassis was then repainted followed by all new original suspension,every bearing and bushing has been replaced with new old stock, all the brake shoes are new along with all the brake springs and adjusters.  All brake hydraulic cylinders are new along with a new master cylinder,drums were turned to correct specs,all brake lines are new and also brake hoses and clips.

The original 6cyl motor is completely redone you can hear it run.  After the machine work, new rings,pistons,valves, valves guides and seals,runs great,all the engine accessories are were rebuilt including the carb,starter,generator, fuel pump, and water pump.  Even the original radiator has been redone and is in perfect condition.

Original Transmission is also rebuilt with all new bearings and seals as well as a new clutch and machined flywheel and pressure plate.   The same for the differential all new bearings and seals.

To top it of it even has all new firestone tires with new tubes that are mounted and balanced including the spare.

This is a running chassis I have driven it about 2 miles and it runs  and stops perfect. I have decided to take my project truck in a different direction and am building a different frame, my loss is definitely your gain.  

I have been told this frame fits 39-47 I don't know for sure so check.  I do need to keep the running board supports so those will be removed.

I have set the reserve for only a fraction of the nearly $10k that I have in this frame and drive line.

Any questions don't hesitate to ask include a phone number if you would like a call back, and if your close you are welcome to come by and hear it run.

Auto Services in Wisconsin

Wildes Transmission ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Auto Transmission
Address: 6720 US Highway 12, Tomah
Phone: (608) 378-4393

Waller`s Auto Glass Express ★★★★★

Automobile Parts & Supplies, Wheel Alignment-Frame & Axle Servicing-Automotive, Brake Repair
Address: 108 W 3rd St N, Ladysmith
Phone: (715) 532-5282

Van Hoof Service ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Towing
Address: Neenah
Phone: (920) 766-9031

Transmission Shop ★★★★★

Automobile Parts & Supplies, Auto Transmission
Address: 211 Lake Ave, Wilmot
Phone: (847) 356-8515

Tracey`s Automotive ★★★★★

Auto Repair & Service, Automobile Diagnostic Service, Automobile Inspection Stations & Services
Address: 802 S 9th Ave, Wausau
Phone: (715) 845-9325

T & N Tire Service ★★★★★

Auto Repair & Service, Tire Dealers, Tire Recap, Retread & Repair
Address: 2923 N Teutonia Ave, New-Berlin
Phone: (414) 562-6211

Auto blog

Chrysler recalling 49K Chargers for headlight components

Fri, 14 Mar 2014

Chrysler has issued a recall for about 49,375 2011 and 2012 Dodge Chargers with halogen headlamps due to a problem with the lights. The automaker says that there could be an issue with the jumper harness and other related components.
The automaker says that 43,450 cars are affected in the US, 2,850 in Canada, 375 in Mexico and 2,700 outside of North America. The vehicles will have their headlight assemblies, including the jumper harnesses and bulbs, inspected and potentially replaced. Dodge says that its engineers investigated reports of that were similar to what was found when it recalled about 10,000 police Chargers in 2012 for overheating light components. There have been no injuries or accidents related to fault, according to Chrysler.
The automaker will be in contact with affected owners, and schedule the service. Naturally, any repairs will be free of charge. Scroll down for the company's full announcement.

What's the deal with Chrysler demanding colleges crush their Vipers? [w/video]

Fri, 07 Mar 2014

Students and teachers at a Washington community college are up in arms following an order from Chrysler that it must destroy the pre-production Dodge Viper that was donated to the school's automotive technology program ten years ago.
The Viper in question is said to be the fourth off the production line, based on its VIN, and has had its emissions controls disabled, allowing its ten-cylinder engine to produce 600 horsepower, according to a report from Yahoo! Autos. As one of the first Vipers ever produced, the school's AT instructors claim it could be worth $250,000 in a museum, while a local news report purports that Jay Leno once tried to purchase the car, but the sale was prevented by Chrysler.
As pointed out by our friends at Autobytel, though, there are a lot of things in this story that don't quite add up. Immediately noticeable from the news report embedded below - which shows the car at South Puget Sound Community College - is that the car in question is not a 1992 model. When the Viper went on sale in 1992, it was only available as an RT/10 with a (flimsy) soft top, like the red car shown above. But the car featured in the report from KING5 News (inset image) is clearly a hardtop Viper GTS, which didn't enter production until 1996. And even if, as reported by a local newspaper, the hardtop featured is a prototype, it doesn't explain the lack of another iconic feature of the first Vipers - their distinctive side pipes. This kind of pokes holes in the school's argument that this is the fourth Viper to ever roll down the line. At best, this appears to be a pre-production Viper GTS.

Question of the Day: Most heinous act of badge engineering?

Wed, Dec 30 2015

Badge engineering, in which one company slaps its emblems on another company's product and sells it, has a long history in the automotive industry. When Sears wanted to sell cars, a deal was made with Kaiser-Frazer and the Sears Allstate was born. Iranians wanted new cars in the 1960s, and the Rootes Group was happy to offer Hillman Hunters for sale as Iran Khodro Paykans. Sometimes, though, certain badge-engineered vehicles made sense only in the 26th hour of negotiations between companies. The Suzuki Equator, say, which was a puzzling rebadge job of the Nissan Frontier. How did that happen? My personal favorite what-the-heck-were-they-thinking example of badge engineering is the 1971-1973 Plymouth Cricket. Chrysler Europe, through its ownership of the Rootes Group, was able to ship over Hillman Avanger subcompacts for sale in the US market. This would have made sense... if Chrysler hadn't already been selling rebadged Mitsubishi Colt Galants (as Dodge Colts) and Simca 1100s as (Simca 1204s) in its American showrooms. Few bought the Cricket, despite its cheery ad campaign. So, what's the badge-engineered car you find most confounding? Chrysler Dodge Automakers Mitsubishi Nissan Suzuki Automotive History question of the day badge engineering question