Dodge Magnum Rt Hemi 5.7, Rims, Halo Headlights, Great On Gas on 2040-cars

Auto blog

Mopar unveils Dodge Challenger Drag Pak [w/video]

Dodge is going drag racing, and it's doing it with an all-new version of the Challenger for NHRA's Sportsman class. FCA's Mopar parts and performance arm announced the new Challenger Drag Pak Friday, showing off a version with a 354-cubic-inch (that's a 5.8-liter, by the way), supercharged V8 and a 426-ci (7.0-liter), naturally aspirated V8 – both Hemis, of course – that can get the big coupes through the quarter-mile in "the eight-second range." While the two engines deliver similar performance, at their base, they're quite a bit different. The supercharged model uses a cast-iron block, while the 426 has aluminum for both the block and head. That said, both models get customized engine calibrations, and are mated to unique, race-spec automatic transmissions. But drag racing is about far more than just outright power. Mopar significantly updated the four-link rear suspension, adding a four-inch rear axle from Strange Engineering, along with an aluminum, nine-inch third member, while the rear-axle housing has been strengthened in general. Both the rear shocks and front struts can be adjusted for rebound and compression, too. Lightweight 15-inch wheels, meanwhile, are shod in super-sticky Hoosier drag radials, with nine inches of tread in back and 4.5 inches in front. The new Challenger Drag Pak should run the quarter-mile in "the eight-second range." In the cabin, there's an NHRA-spec roll cage, a Racepak gauge cluster, and a handsome pair of Sparco racing seats. Outside, supercharged models get blue decals, while naturally aspirated varieties get black stickers, although there's more to the new Challenger dragster's exterior than just its decals. Mopar tweaked the big-scoop hood, promising it's easier to get up to check on the engine, and the designers also added trailer tie-down straps in both the front and rear. While the dragster was the big news today, Mopar officials also announced the two enhanced Scat Pack kits for both the Dodge Charger and Challenger R/T. The 5.7-liter Hemi models gain an extra 56 horsepower and 30 pound-feet of torque in the Scat Pack 2 thanks to a new cam, valve springs, pushrods, and gaskets. The Scat Pack 3, meanwhile, adds 75 hp and 44 lb-ft, on top of the gains from the lower packages. That should be perfect for drivers who wish to snort in the face of their SRT 392-driving friends. The third stage adds a ported cylinder heads, as well as high-flow manifolds and catalysts.

Cruiser's close call caught on camera

A new recruit to the Kansas Highway Patrol experienced his first brush with danger on his first day when a semi truck clipped his cruiser during a traffic stop last week. Public relations officer Tod Hileman said in a Facebook post that the incident occurred when an officer and his brand-new trainee pulled over a black Dodge Charger on I-70 in Trego County, Kansas. Hileman said in the comments that the cruiser was parked two feet away from the white line on the shoulder. Not only did the driver not get over a lane when he saw the stopped cruiser per Kansas law, he seemed to have moved closer to the side of the road. The big rig managed to send the cruiser's side mirror and spotlight flying across the road. The truck could have easily injured one of the officers, perhaps fatally. The truck driver ignored Kansas' Move Over law, which requires "drivers approaching a stationary emergency vehicle displaying flashing lights, including towing and recovery vehicles, traveling in the same direction, to vacate the lane closest if safe and possible to do so, or slow to a speed safe for road, weather, and traffic conditions." With a clear lane to his left the trucker in this case had no excuse. He stopped after the crash and was cited by the officers for failing to change lanes when he saw the stopped vehicles. Being a cop is a risky job. So far this year, 28 officers have lost their lives in the line of duty due to car accidents, according to the Officer Down Memorial Page. News Source: Facebook Government/Legal Dodge Videos traffic traffic stop traffic tickets move over law

Will the Chrysler 300 go front-wheel drive?

FCA chief executive Sergio Marchionne hinted last week that the strapping rear-wheel-drive Chrysler 300 sedan could go front-wheel drive for its next generation using the underpinnings from the Chrysler Pacifica minivan. Speaking at the Pacifica's production launch in Windsor, ON, Marchionne said, "this plant and this architecture is capable of making the 300 successor, the front-wheel, all-wheel-drive successor," Reuters reported. Perhaps realizing he appeared to be announcing a dramatic shift in product strategy, Marchionne backpedaled in response to a follow-up question, noting only that the Ontario factory is "capable" of making the sedan. "It's capable. It's not a commitment," he said, according to Reuters. The 300 is currently built in Brampton, ON, alongside the mechanically similar Dodge Charger and Challenger. The platform, known as LX in enthusiast circles, is an evolution of Mercedes-based chassis pieces that date to the DaimlerChrysler era. Marchionne's comments didn't cover the Dodges and left a lot open to interpretation. The 300 could switch to front- and all-wheel-drive and focus on a more civilized, elegant ride character, leaving the Charger and two-door Challenger as traditional rear-wheel-drive muscle cars. That strategy would further differentiate the Chrysler and Dodge car lines. Additionally, the Charger's RWD platform makes it a popular police vehicle, and both Dodges are offered in top trim as 707-horsepower Hellcats. Switching to front-wheel drive would seemingly complicate both of those endeavors. Rumors have also swirled that Alfa Romeo could contribute RWD underpinnings for Dodge. Related Video: Featured Gallery 2015 Chrysler 300 View 92 Photos Design/Style Chrysler Dodge Off-Road Vehicles Performance Sedan chrysler pacifica