2001 Dodge Grand Caravan on 2040-cars

Auto blog

Dodge engineers trying to shoehorn Pentastar into Dart?

The fact that the Dart's launch has been a pretty dismal affair isn't what we'd call secret. Judging by its mounting inventories and poor critical reception, Dodge's successor to its unloved Caliber has struggled since it hit the market. And while both of those are difficult problems to address, at least their cause is well known - the powertrain.
Even Fiat-Chrysler CEO Sergio Marchionne has acknowledged that the powertrain options in the Dart are substandard, admitting at January's Detroit Auto Show that the powertrains are "less than ideal." Leading with the 1.4-liter turbocharged four-cylinder found in the Fiat 500 Abarth left a bad taste in the mouths of consumers thanks to the laggy engine and dead throttle response (to say nothing of the manual and dual-clutch gearboxes that needed more refinement). The addition of the 184-horsepower 2.4-liter Tigershark in the Dart GT has helped matters some, but apparently Auburn Hills doesn't think it's quite enough.
If rumors are to be believed - get that salt ready - a possible solution may be in the works. A report from Allpar is claiming that Dodge is considering fitting a Pentastar V6 into the Dart's engine bay. As the Mopar-obsessed website points out, the critically acclaimed Pentastar is available in three different sizes - 3.0 liters, 3.2 liters and the original 3.6 liters. We don't get the 3.0 here in the US, but the 3.2 can be found in the new Jeep Cherokee and the 3.6 has been seemingly fitted to every model Chrysler can shoehorn it into.

Mopar unveils Dodge Challenger Drag Pak [w/video]

Dodge is going drag racing, and it's doing it with an all-new version of the Challenger for NHRA's Sportsman class. FCA's Mopar parts and performance arm announced the new Challenger Drag Pak Friday, showing off a version with a 354-cubic-inch (that's a 5.8-liter, by the way), supercharged V8 and a 426-ci (7.0-liter), naturally aspirated V8 – both Hemis, of course – that can get the big coupes through the quarter-mile in "the eight-second range." While the two engines deliver similar performance, at their base, they're quite a bit different. The supercharged model uses a cast-iron block, while the 426 has aluminum for both the block and head. That said, both models get customized engine calibrations, and are mated to unique, race-spec automatic transmissions. But drag racing is about far more than just outright power. Mopar significantly updated the four-link rear suspension, adding a four-inch rear axle from Strange Engineering, along with an aluminum, nine-inch third member, while the rear-axle housing has been strengthened in general. Both the rear shocks and front struts can be adjusted for rebound and compression, too. Lightweight 15-inch wheels, meanwhile, are shod in super-sticky Hoosier drag radials, with nine inches of tread in back and 4.5 inches in front. The new Challenger Drag Pak should run the quarter-mile in "the eight-second range." In the cabin, there's an NHRA-spec roll cage, a Racepak gauge cluster, and a handsome pair of Sparco racing seats. Outside, supercharged models get blue decals, while naturally aspirated varieties get black stickers, although there's more to the new Challenger dragster's exterior than just its decals. Mopar tweaked the big-scoop hood, promising it's easier to get up to check on the engine, and the designers also added trailer tie-down straps in both the front and rear. While the dragster was the big news today, Mopar officials also announced the two enhanced Scat Pack kits for both the Dodge Charger and Challenger R/T. The 5.7-liter Hemi models gain an extra 56 horsepower and 30 pound-feet of torque in the Scat Pack 2 thanks to a new cam, valve springs, pushrods, and gaskets. The Scat Pack 3, meanwhile, adds 75 hp and 44 lb-ft, on top of the gains from the lower packages. That should be perfect for drivers who wish to snort in the face of their SRT 392-driving friends. The third stage adds a ported cylinder heads, as well as high-flow manifolds and catalysts.

Fiat Chrysler expands Takata airbag recall to 3.3M vehicles

Fiat Chrysler Automobiles is expanding its recall of vehicles equipped with Takata airbags, moving beyond Florida, Hawaii, Puerto Rico and the US Virgin Islands to the greater US, as well as Mexico, Canada and beyond. The affected vehicles, some 3.3 million in total, were built between 2004 and 2007, with many models, including the Dodge Ram 1500, 2500 and 3500, Durango and the Chrysler 300, having been affected by Chrysler's previous recall. Despite the somewhat alarming nature that comes with a recall of this many vehicles, it seems that Chrysler is moving more out of an abundance of caution (and federal pressure) than anything else, saying: "Neither FCA US, nor Takata Corporation, the supplier, has identified a defect in this population of inflators. These components also are distinct from Takata inflators cited in fatalities involving other auto makers. More than 1,000 laboratory tests have been performed on these components. All deployed as intended, but FCA US continues to study the suspect inflators, which are not used in the Company's current production vehicles." Owners of affected vehicles will be notified and asked to report to dealers for a free replacement driver's side airbag. Scroll down for the official press release from FCA. Statement: Global Air-Bag Inflator Replacement December 19, 2014 , Auburn Hills, Mich. - FCA US LLC will replace driver's-side air-bag inflators in an estimated 3.3 million older-model vehicles worldwide, in an expansion of an ongoing regional field action. Neither FCA US, nor Takata Corporation, the supplier, has identified a defect in this population of inflators. These components also are distinct from Takata inflators cited in fatalities involving other auto makers. More than 1,000 laboratory tests have been performed on these components. All deployed as intended, but FCA US continues to study the suspect inflators, which are not used in the Company's current production vehicles. Outside of Florida, one of the areas covered by the original action, no FCA US vehicle has been linked to an air-bag deployment of the type that has raised public concern. Nevertheless, the Company is replacing the Takata components tied to that concern. FCA US is aware of one related injury involving one of its vehicles, an older-model sedan. It occurred in a southern Florida region marked by persistent, high, absolute humidity – a condition believed to be a contributing factor in the air-bag deployments under investigation.