Dodge Dart Seneca 1960 2 Door Sedan Rat Rod on 2040-cars
Baraboo, Wisconsin, United States
Very solid Nebraska car with 1 hole in passenger side floor board (picture) minor rust thru on lower rear quarters. Top end of engine has been rebuilt along with new Offy intake, Holley carbs, linkage, water pump, fuel pump, ignition kit, master cylinder, custom fit brake lines, clutch, throw out bearing and chrome valve cover. Gas tank has been cleaned and coated. The underside of the body has also been cleaned & coated with por-15 I have extra front fenders ,windshield glass, tail light housings, dash (automatic), 3/4 a gallon of Viper red acrylic automotive paint and various other parts I have picked up over the 13 years I have owned this car. This car has been stored inside since I have owned it. I had a clear Nebraska title but lost it before I was able to transfer it to my name so this car will be sold with bill of sale only. The listing above would not allow me to enter "Other" in the Title section. |
Dodge Dart for Sale
- 2013 dart sxt *black edition* 6-speed powertech automatic 8.4" u-connect screen(US $14,425.00)
- 1969 dodge dart gts 383 h code rare only 488 made
- 1969 dodge dart gts 340c.i./275h.p. only 2623 made
- New 2013 dodge dart rallye orange crush! - $272 p/mo, $200 down!(US $17,995.00)
- 1967 dodge dart gt pro-street(US $17,500.00)
- 1975 dodge dart demon 360 clone no reserve !!! mopar muscle
Auto Services in Wisconsin
Wrench`s Repair ★★★★★
Superior Automotive ★★★★★
Southside Tire Co Inc ★★★★★
Shawano Service ★★★★★
Sedlak Chevrolet Buick ★★★★★
Quince Auto Sales ★★★★★
Auto blog
SRT reveals Satin Vapor Edition 300, Charger and Challenger SRT models
Fri, 07 Feb 2014With the exception of some notable truck and van introductions, Chrysler brands have tended to use the Chicago Auto Show to bring out new special editions, pimp their aftermarket parts support or indulge in the occasional flight of fancy. That plan is holding true for 2014, as well. Cases in point are these new Satin Vapor Editions of the 2014-model-year Dodge Challenger, Dodge Charger and Chrysler 300 - all from SRT.
The Satin Vapor name may sound like a failed 1970s glam-rock band, or a pseudo-gynecological diagnosis from the Old West, but is, in fact, pretty much a tape-and-trim package for this trio of hi-po Mopars. 300, Challenger and Charger alike come shod with 20-inch aluminum wheels finished in Black Satin Vapor Chrome, and are accented with Satin Black bits aplenty. The 300 gets blacked-out mirrors, spoiler and roof; the Challenger applies it to mirrors and its fuel door; while the Charger has the stuff covering its roof, hood and Super Bee tail graphic.
Interiors of the cars have been mildly updated as well, with all three getting some combination of Nappa leather, ultra-suede and carbon-fiberish finishes.
Dodge Challenger spied exercising supercharged Hellcat Hemi V8
Wed, 23 Oct 2013One of the prime complaints against the Dodge Challenger is that, even in SRT8 guise, its 470 horsepower is responsible for hauling over 4,200 pounds of vehicle. For comparison, the 420 hp in the Ford Mustang GT only has to deal with 3,618 lbs. Things only get worse from there, as the higher-performance variants of both the Mustang and the Chevrolet Camaro are far more powerful than an SRT8 without adding on much heft.
So what is Chrysler to do? The correct answer is add a whole lot more grunt to its hefty two-door and even the odds. That's where the all-new Hellcat engine comes into play. We reported on this engine in May, and suggested that the Hellcat, a supercharged powerplant based on a 6.4-liter V8, would easily generate 500 to 570 hp and could likely arrive boasting more than 600 ponies.
Chrysler's ace in its sleeve has now been spied testing, with a number of Hellcat-equipped Challengers running the potent new engine both in more urbanized areas and under the sun of Death Valley. The hoods on these testers have been raised to accommodate the engine, and that camouflage over the fascias of these prototypes is there to hide a larger air intake. We also note what appears to be a new split grille under wraps. As for power output, our spies are now suggesting a Viper-equalling 640 hp from the Hellcat-equipped cars.
Fiat Chrysler CEO says final merger talks with Peugeot going well
Thu, Jan 23 2020BRUSSELS — Fiat Chrysler's chief executive Michael Manley said on Wednesday that merger talks with Peugeot owner PSA to create the world's No. 4 carmaker are progressing well and he hopes to have a deal within 12-14 months. Speaking to Reuters on the sidelines of an industry meeting, he said he doesn't expect any major obstacles that could delay a final agreement. "Talks are progressing really well," Manley said about negotiations with the French carmaker ahead of a briefing by the European automotive association (ACEA), of which he is president. His comments come a month after the two carmakers agreed to a binding deal worth about $50 billion to combine forces in response to a slowdown in global demand and mounting costs of making cleaner vehicles amid tighter emissions regulations. Manley's timeline for completing the deal by early 2021 is in line with a forecast made by the companies in December. Fiat and Peugeot are now getting into the details of how the merger will work, including choosing which vehicle platforms — the technological underpinnings of a vehicle — will fit which products in a combined company. Because customers in different locations still prefer vastly different cars, there is room for multiple platforms in a combined group, Manley said. "That global platform is an elusive beast," he added. "This concept of a massive global platform in my mind is almost a myth, but that doesnÂ’t mean to say weÂ’re not going to recruit significant volume." Related Video:  Â