1962 Dodge Dart Convertible Project Vert 62 413 440 Polara Convertable Hot Rod on 2040-cars

Auto blog

2015 Dodge Charger Pursuit prepares to keep Hellcats in line

Earlier today, Dodge pulled the wraps off its 2015 Charger SRT Hellcat - a 707-horsepower sedan capable of sprinting to 60 miles per hour in 3.7 seconds and reaching a top speed of 204 mph. Naturally, the car debuted in a bright shade of pull-me-over red, so it was fitting, then, that Dodge also brought its newly updated 2015 Charger Pursuit to keep everything under control.
No, cops won't be able to spec their Charger cruisers with the 707-hp Hellcat engine (oh man, imagine the chase scenes...), but law enforcement officials will be able to choose from either a 3.6-liter V6 or 5.7-liter Hemi V8, producing 292 hp and 370 hp, respectively. V8 models can be ordered with all-wheel drive, and Dodge estimates that with either engine, the Charger Pursuit can achieve up to 26 miles per gallon on the highway (thanks to the V8's four-cylinder mode).
Other updates for 2015 include improved braking power, a seven-inch display in the instrument cluster, a five-inch display in the center stack, and a new vehicle systems interface that could make it easier for police squads to install computer and radio equipment.

Chrysler extends fuel tank warranties on LX cars, NHTSA ends probe

The National Highway Traffic Safety Administration has ended its investigation of 153,817, 5.7-liter and 6.1-liter Hemi V8-powered 2006 Chrysler 300, Dodge Charger and Dodge Magnum models after reports of stalling. Chrysler has responded by granting a lifetime warranty on the fuel tanks for these vehicles.
NHTSA received 299 reports of engines stalling while the models were stopped or driving at low speeds, and began an investigation. The government agency found that the control valve shutoff float in the V8s' 19-gallon fuel tank could malfunction if the fuel had too high of an ethanol content. In many cases, the valve would break in the open position, allowing the tank to be overfilled, which would then cause the cars to stall. However, there were no accidents reported, and the vehicles could be restarted immediately.
There will not be a recall on these vehicles because, "the condition represents a low risk to motor vehicle safety and is adequately addressed by Chrysler's extended warranty," NHTSA said to The Detroit News.

Chrysler says its 8-speed transmissions will save 700 million gallons

Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.