Find or Sell Used Cars, Trucks, and SUVs in USA

2000 Dodge Dakota Slt Crew Cab Pickup 4-door 4.7l on 2040-cars

Year:2000 Mileage:227261
Location:

Fillmore, Indiana, United States

Fillmore, Indiana, United States
Advertising:

 Pay with paypal will not deliver pickup only, well maintained, passenger side seat has a slight tear

Auto Services in Indiana

Williams Auto Parts Inc ★★★★★

Automobile Parts & Supplies, Used & Rebuilt Auto Parts, Automobile Electrical Equipment
Address: 127 S Detroit Ave, Portland
Phone: (866) 943-9403

Williams Auto Parts Inc ★★★★★

Automobile Parts & Supplies, Used & Rebuilt Auto Parts, Automobile Electrical Equipment
Address: 127 S Detroit Ave, Saratoga
Phone: (866) 943-9403

Webb Hyundai ★★★★★

New Car Dealers, Used Car Dealers
Address: 9236 Indianapolis Blvd, Highland
Phone: (219) 923-2277

Trusty & Sons Tire Co ★★★★★

Auto Repair & Service, Tire Dealers, Brake Repair
Address: 1074 Old Forest Rd NW, Corydon
Phone: (812) 738-4212

Tom Roush Lincoln Mazda ★★★★★

New Car Dealers, Used Car Dealers
Address: 525 David Brown Dr, Westfield
Phone: (866) 869-7884

Tire Barn Warehouse ★★★★★

Auto Repair & Service, Tire Dealers, Wheels-Aligning & Balancing
Address: 9821 Lima Rd, Fort-Wayne
Phone: (260) 490-8473

Auto blog

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Mon, 08 Oct 2012

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

Cars.com runs 11-second quarter with Dodge Charger Hellcat

Mon, Jun 1 2015

The Dodge Charger SRT Hellcat and its Challenger sibling are two of the heroes of the modern performance world. With a headline-grabbing 707 horsepower from a supercharged 6.2-liter V8, their output even shames many supercars. But how quick can one really cover a quarter mile? Cars.com recently decided to find out by taking a Charger Hellcat to the drag strip to see if the sedan lived up to Dodge's 11-second claims. The results were quite impressive. After 13 quarter-mile runs of adjusting variables like the tire pressures and the car's various electronic aids, the Charger Hellcat managed a pass in 11.03 seconds at 126.61 mph – the pinnacle result of the day. This car was mechanically stock and wore the optional Pirelli P Zero tires. According to Cars.com, other quick sprints reached 11.09 seconds and 11.1 seconds, which even beat the site's 11.41-second best from a Challenger Hellcat last year. Getting the Hellcat's prodigious power down without losing traction was a challenge, even on the summer tires. Cars.com thought it had a run that could have dropped below 11 seconds, but then the wheels spun. Using the factory-recommended pressures, the Charger Hellcat was no still slouch with an 11.27-second time recorded, but taking things down to 25 psi proved the quickest at the strip. We already knew that the Charger Hellcat was a wonderful vehicle for eating up huge gulps of asphalt at high speeds and could verify its 204-mile-per-hour top speed (quite a bit faster, incidentally, than the Ferrari California T's 196 mph top-speed). Apparently, the 11-second quarter-mile claim is just as accurate. Also, for any curious owners, the Cars.com story divulges many of the tweaks required to reach this seriously quick time. Related Video:

The Chrysler brand could be axed under Stellantis management

Sun, Jan 3 2021

MILAN — While running NissanÂ’s North American operations from 2009 to 2011, Carlos Tavares had a reputation for closely watching costs with little tolerance for vehicles or ventures that didnÂ’t make money. Experts say that means Tavares, currently the head of PSA Group, is likely to follow that blueprint when he becomes leader of a merged PSA and Fiat Chrysler Automobiles. The low-performing Chrysler brand might get the axe as could slow-selling cars, SUVs or trucks that lack potential. Already the companies are talking about consolidating vehicle platforms — the underpinnings and powertrains — to save billions in engineering and manufacturing costs. That could mean job losses in Italy, Germany and Michigan as PSA Peugeot technology is integrated into North American and Italian vehicles. “You canÂ’t be cost efficient if you keep the entire scale of both companies,” said Karl Brauer, executive analyst for the iSeeCars.com auto website. “WeÂ’ve seen this show before, and weÂ’re going to see it again where they economize these platforms across continents, across multiple markets.” Shareholders of both companies are to meet Monday to vote on the merger to form the worldÂ’s fourth-largest automaker, to be called Stellantis. The deal received EU regulatory approval just before Christmas. Tavares, who for years has wanted to sell PSA vehicles in the U.S., wonÂ’t take full control of the merged companies until the end of January at the earliest. He likely will target Europe for consolidation first, because thatÂ’s where Fiat vehicles overlap extensively with PSAÂ’s, said IHS Markit Principal Auto Analyst Stephanie Brinley. Europe has been a money-loser for FCA, and factories in Italy are operating way below capacity — a concern for unions, given FiatÂ’s role as the largest private sector employer in the country. “We are at a crossroads,Â’Â’ said Michele De Palma of the FIOM CGIL metalworkersÂ’ union. “Either there is a relaunch, or there is a slow agonizing closure of industry, in particular the auto industry, in Italy.” ItalyÂ’s hopes lie with the luxury Maserati and sporty Alfa Romeo brands, but De Palma said investments are needed to bring hybrid and electric technology up to speed. FiatÂ’s Italian capacity stands at 1.5 million vehicles, but only a few hundred thousand are being produced each year. Most factories were on rolling short-term layoffs due to lack of demand, even before the pandemic.